相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Processing of T6 heat-treated Al-12Si-0.6Mg alloy
Senol Bayraktar et al.
MATERIALS AND MANUFACTURING PROCESSES (2020)
Certain Aspects of Particle Distribution in Castings Formed in Rotating Moulds
Shubhashree Mohapatra et al.
ANNALES DE CHIMIE-SCIENCE DES MATERIAUX (2019)
Effects of Cutting Speed on Chip Characteristics and Tool Wear Mechanisms During Dry Machining of Inconel 718 Using Uncoated WC Tool
Merugu Rakesh et al.
ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING (2019)
Comparative study of the effect of surface texturing on cutting tool in dry cutting
S. Jesudass Thomas et al.
MATERIALS AND MANUFACTURING PROCESSES (2018)
Effects of nano-cutting fluids on tool performance and chip morphology during machining Inconel 718
H. Hegab et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2018)
An analytical force mode applied to three-dimensional turning based on a predictive machining theory
Zhongtao Fu et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2018)
Influence of dimple and spot-texturing of HSS cutting tool on machining of Ti-6Al-4V
Mayur S. Sawant et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2018)
Processing and properties evaluation of functionally continuous graded 7075 Al alloy/SiC composites
T. Ram Prabhu
ARCHIVES OF CIVIL AND MECHANICAL ENGINEERING (2017)
Effect of cutting conditions on wear performance of cryogenically treated tungsten carbide inserts in dry turning of stainless steel
Nursel Altan Ozbek et al.
TRIBOLOGY INTERNATIONAL (2016)
The relationship between the cutting speed, tool wear, and chip formation during Ti-5553 dry cutting
Vincent Wagner et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2015)
A new analytical tool-chip friction model in dry cutting
Fangjuan Zhou
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2014)
Effect of solidification rate on the morphology and distribution of eutectic carbides in centrifugal casting high-speed steel rolls
Yikun Luan et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2010)
Characteristics of two Al based functionally gradient composites reinforced by primary Si particles and Si/in situ Mg2Si particles in centrifugal casting
Zhai Yan-bo et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2010)
An investigation of the tool-chip contact length and wear in high-speed turning of EN19 steel
NA Abukhshim et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2004)
Numerical simulation of microstructure evolution of Al alloys in centrifugal casting
SR Chang et al.
ISIJ INTERNATIONAL (2001)
分享论文
