The influence of bearing surfaces on revisions due to dislocations in total hip arthroplasty

Introduction Recurrent dislocations are still the most frequent reason for revision in total hip arthroplasty (THA). The impact of bearing surfaces on dislocations is still controversial. We hypothesized that: (1) bearing surfaces influence the revisions due to dislocations; (2) ceramic-on-ceramic reduced the revisions for dislocations in adjusted models; (3) Delta-on-Delta bearings reduced the revisions for dislocations in comparison to surfaces with cross-linked polyethylene. Materials and methods The regional arthroplasty registry was enquired about bearing surfaces and revisions for dislocations and instability. Unadjusted and adjusted rates were provided, including sex, age (<65 years or >= 65 years), head diameter (<= 28 mm or >28 mm; <36 mm or >= 36 mm) as variables. 44,065 THAs were included. Results The rate of revisions for dislocations was significantly lower in ceramic-on-ceramic and metal-on-metal bearings (unadjusted rates). After adjusting for age, sex, and head size (36 and 28 mm), hard-on-hard bearings were protective (p < 0.05): ceramic-on-ceramic had a lower risk of revisions due to dislocation than ceramic-on-polyethylene (HR 1.6, 95% CI 1.2-2.2 p = 0.0009). The rate of revisions for dislocation was similar in bearings with cross-linked polyethylene and Delta-on-Delta articulations, in unadjusted and adjusted models. Conclusion Bearings with conventional polyethylene were more predisposed to dislocations. Currently adopted bearings exerted no significant influence on revisions due to dislocations. These findings could be primarily related to wear, but due to the time distribution, soft tissue envelopes and surface tension may also play a role. Pre-clinical biomechanical evaluations and prospective matched cohort studies are required to draw definitive conclusions. [GRAPHICS] .

Automated summary

Recurrent dislocations remain a common reason for revision in total hip arthroplasty, with ceramic-on-ceramic bearings showing a lower risk of revisions due to dislocation in adjusted models compared to ceramic-on-polyethylene. However, there was no significant difference in the rate of revisions for dislocation between bearings with cross-linked polyethylene and Delta-on-Delta articulations in both unadjusted and adjusted models. Additional studies are needed to draw definitive conclusions about the influence of bearing surfaces on revisions due to dislocations.