相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Diffusional behaviors and mechanical properties of Cu-Zn system
Ke Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2020)
Investigation of the early stage of reactive interdiffusion in the Cu-Al system by in-situ transmission electron microscopy
F. Moisy et al.
MATERIALIA (2020)
Cu-Al interfacial formation and kinetic growth behavior during HTS reliability test
Chien-Pan Liu et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2019)
Investigation of diffusion behavior and mechanical properties of Mg-Zn system
Yifang Ouyang et al.
CALPHAD-COMPUTER COUPLING OF PHASE DIAGRAMS AND THERMOCHEMISTRY (2019)
Optimisation of interface formation by shear inclination: Example of aluminium-copper hybrid produced by ECAP with back-pressure
Alexander E. Medvedev et al.
MATERIALS & DESIGN (2018)
Evolution of bonding interface in solid-liquid cast-rolling bonding of Cu/Al clad strip
Hua-gui Huang et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2017)
Thermodynamic assessment of the Al-Cu-Zn system, part II: Al-Cu binary system
Song-Mao Liang et al.
CALPHAD-COMPUTER COUPLING OF PHASE DIAGRAMS AND THERMOCHEMISTRY (2015)
Diffusion kinetics, mechanical properties, and crystallographic characterization of intermetallic compounds in the Mg-Zn binary system
C. C. Kammerer et al.
INTERMETALLICS (2015)
Bimetallic copper-aluminium tube by severe plastic deformation
Rimma Lapovok et al.
SCRIPTA MATERIALIA (2012)
Re-investigation of phase equilibria in the system Al-Cu and structural analysis of the high-temperature phase η1-Al1-δCu
Norbert Ponweiser et al.
INTERMETALLICS (2011)
Nanoindentation in materials research: Past, present, and future
Warren C. Oliver et al.
MRS BULLETIN (2010)
Numerical analysis for migration of interface between liquid and solid phases during reactive diffusion in the binary Cu-Al system
Y. Tanaka et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)
A critical appraisal of the extraction of creep parameters from nanoindentation data obtained at room temperature
R. Goodall et al.
ACTA MATERIALIA (2006)
CuAl2 revisited:: Composition, crystal structure, chemical bonding, compressibility and Raman spectroscopy
Yuri Grin et al.
JOURNAL OF SOLID STATE CHEMISTRY (2006)
Continuous strain bursts in crystalline and amorphous metals during plastic deformation by nanoindentation
H Li et al.
JOURNAL OF MATERIALS RESEARCH (2005)
Effects of intermetallic compound on the electrical and mechanical properties of friction welded Cu/Al bimetallic joints during annealing
WB Lee et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2005)
Correcting power-law viscoelastic effects in elastic modulus measurement using depth-sensing indentation
AHW Ngan et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2005)
Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodology
WC Oliver et al.
JOURNAL OF MATERIALS RESEARCH (2004)
The crystal structure of ζ2-Al3Cu4-δ
LD Gulay et al.
ZEITSCHRIFT FUR ANORGANISCHE UND ALLGEMEINE CHEMIE (2003)
Rate-dependent indentation hardness of a power-law creep solder alloy
X Ma et al.
APPLIED PHYSICS LETTERS (2003)
Investigation of creep behaviour under load during indentation experiments and its influence on hardness and modulus results
T Chudoba et al.
SURFACE & COATINGS TECHNOLOGY (2001)
分享论文
