相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Direct numerical simulations of laminar and transitional flows in diverging pipes
Dhanush Vittal Shenoy et al.
INTERNATIONAL JOURNAL OF NUMERICAL METHODS FOR HEAT & FLUID FLOW (2020)
Techno-economic assessment of potato waste management in developing economies
Josef Marousek et al.
CLEAN TECHNOLOGIES AND ENVIRONMENTAL POLICY (2020)
Numerical study of heat transfer in gravity-driven dense particle flow around a hexagonal tube
Xing Tian et al.
POWDER TECHNOLOGY (2020)
Feasibility limits of using low-grade industrial waste heat in symbiotic district heating and cooling networks
Maurizio Santin et al.
CLEAN TECHNOLOGIES AND ENVIRONMENTAL POLICY (2020)
Advances in nutrient management make it possible to accelerate biogas production and thus improve the economy of food waste processing
Josef Marousek et al.
ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS (2020)
Bioenergy with carbon emissions capture and utilisation towards GHG neutrality: Power-to-Gas storage via hydrothermal gasification
Daniel Fozer et al.
APPLIED ENERGY (2020)
Unsteady CFD simulation on ash particle deposition and removal characteristics in tube banks: Focusing on particle diameter, flow velocity, and temperature
Lin Mu et al.
JOURNAL OF THE ENERGY INSTITUTE (2020)
Waste heat recovery through organic flash cycle (OFC) using R245fa-R600 mixture as the working fluid
Subha Mondal et al.
CLEAN TECHNOLOGIES AND ENVIRONMENTAL POLICY (2019)
Fouling and thermal-hydraulic characteristics of aligned elliptical tube and honeycomb circular tube in flue gas heat exchangers
Song-Zhen Tang et al.
FUEL (2019)
Fouling characteristics analysis and morphology prediction of heat exchangers with a particulate fouling model considering deposition and removal mechanisms
Song-Zhen Tang et al.
FUEL (2017)
Numerical simulation and experiment of gas-solid two phase flow and ash deposition on a novel heat transfer surface
Jinbo Li et al.
APPLIED THERMAL ENGINEERING (2017)
Simulation of real time particle deposition and removal processes on tubes by coupled numerical method
Zi-Xiang Tong et al.
APPLIED ENERGY (2017)
Unsteady CFD analysis of kraft recovery boiler fly-ash trajectories, sticking efficiencies and deposition rates with a mechanistic particle rebound-stick model
Manuel Garcia Perez et al.
FUEL (2016)
Numerical model of particle deposition on fin surface of heat exchanger
Feilong Zhan et al.
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID (2016)
CFD modeling of mixing intensification assisted with ultrasound wave in a T-type microreactor
Masoud Rahimi et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2014)
A parameter study of tube bundle heat exchangers for fouling rate reduction
Hui Han et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2014)
Fly ash deposition modelling: Requirements for accurate predictions of particle impaction on tubes using RANS-based computational fluid dynamics
Roman Weber et al.
FUEL (2013)
Carbon and nitrogen trade-offs in biomass energy production
Lidija Cucek et al.
CLEAN TECHNOLOGIES AND ENVIRONMENTAL POLICY (2012)
Numerical evaluation of a heat exchanger with inline tubes of different size for reduced fouling rates
Sofia G. Mavridou et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2012)
Simulation of Coal Ash Particle Deposition Experiments
Weiguo Ai et al.
ENERGY & FUELS (2011)
Influence of the Apex Angle of Cone-Shaped Tubes on Particulate Fouling of Heat Exchangers
Mohamed S. Abd-Elhady et al.
HEAT TRANSFER ENGINEERING (2011)
Experimental and CFD studies on using coil wire insert in a proton exchange membrane fuel cell
M. Rahimi et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2010)
Rebound characteristics for 50-μm particles impacting a powdery deposit
M. C. van Beek et al.
POWDER TECHNOLOGY (2006)
Particle sticking/rebound criteria at oblique impact
AG Konstandopoulos
JOURNAL OF AEROSOL SCIENCE (2006)
Computational study of fouling deposit due to surface-coated particles in coal-fired power utility boilers
BE Lee et al.
FUEL (2002)
分享论文
