4.7 Article

Favorable morphology and electronic conductivity of functional sublayers for highly efficient water splitting electrodes

期刊

JOURNAL OF ENERGY STORAGE
卷 36, 期 -, 页码 -

出版社

ELSEVIER
DOI: 10.1016/j.est.2021.102342

关键词

Water splitting; Nanoporous morphology; Conductivity; Functional sublayers; Visualization; Ohmic resistance

资金

  1. U.S. Department of Energy's Office of Energy Efficiency and Renewable Energy (EERE) under the Fuel Cell Technologies Office [DE-EE0008426, DE-EE0008423]
  2. U.S. Department of Energy's Office of Energy Efficiency and Renewable Energy (EERE) under National Renewable Energy Laboratory [DE-AC36-08GO28308]
  3. U.S. Department of Energy's Office of Energy Efficiency and Renewable Energy (EERE) under National Energy Technology Laboratory [DE-FE0011585]

向作者/读者索取更多资源

The study revealed that introducing conductive sublayers with different conductivities and morphologies into membrane-based water electrolyzers can significantly improve the sheet conductivity of anode electrodes, reduce the ohmic resistance of water electrolyzers, and increase the current density of water splitting. Carbon nanotube (CNT) film provided a higher electrochemical active area than Au mesh, leading to improved water electrolysis performance.
Low electronic conductivities and improper morphologies of anode electrodes greatly limit the reaction area, catalyst utilization and efficiency in proton exchange membrane water electrolyzers. In this study, conductive sublayers with different conductivities and morphologies were introduced into anode electrodes in membrane-based water electrolyzers. In-situ and ex-situ investigation results showed that conductive sublayers (Au mesh and carbon nanotube (CNT) film) augmented the sheet conductivity of anode electrodes by up to 4000 times (from 2000 to 0.5 ohm square(-1)), and the ohmic resistance of water electrolyzers was reduced to 1/3 when inserting conductive sublayers. In addition, CNT film provided a higher electrochemical active area than Au mesh, because of favorable morphologies (large porosity and surface area) of CNT fibers on CNT films. Therefore, the current density of water splitting was increased by 3 times (from 4.55 mA cm(-2) to 14.83 mA cm(-2)) at 2.5 V compared to a conventional anode electrode. Visualizations on bubble dynamics showed improved performances with conductive sublayers; this was mainly due to greatly increased number of reaction sites, highly spread reaction area (from 50 to 1000 um), and reduced activation overpotential. Thus, a balance between high electronic conductivity and nanoporous morphology is essential to the anode electrode for larger reaction sites and areas in highly efficient water electrolyzers.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.7
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据