相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Carbide-bonded graphene-based Joule heating for embossing fine microstructures on optical glass
Lihua Li et al.
APPLIED SURFACE SCIENCE (2020)
The Tool Life and Coating-Substrate Adhesion of AlCrSiN-Coated Carbide Cutting Tools Prepared by LARC with Respect to the Edge Preparation and Surface Finishing
Tomas Vopat et al.
MICROMACHINES (2020)
Modeling of Cutting Parameters and Tool Geometry for Multi-Criteria Optimization of Surface Roughness and Vibration via Response Surface Methodology in Turning of AISI 5140 Steel
Mustafa Kuntoglu et al.
MATERIALS (2020)
A critical review on the chemical wear and wear suppression of diamond tools in diamond cutting of ferrous metals
Guo Jiang et al.
INTERNATIONAL JOURNAL OF EXTREME MANUFACTURING (2020)
Oxygen-shielded ultrasonic vibration cutting to suppress the chemical wear of diamond tools
XinQuan Zhang et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2019)
Influence of Different Grades of CBN Inserts on Cutting Force and Surface Roughness of AISI H13 Die Tool Steel during Hard Turning Operation
Pardeep Kumar et al.
MATERIALS (2019)
Ultrasonic tooling system design and development for single point diamond turning (SPDT) of ferrous metals
Rimvydas Gaidys et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2017)
Ductile machining of single-crystal silicon for microlens arrays by ultraprecision diamond turning using a slow tool servo
Mao Mukaida et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2017)
A study of the diamond tool wear suppression mechanism in vibration-assisted machining of steel
XinQuan Zhang et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2014)
Experimental study on ultrasonic elliptical vibration cutting of hardened steel using PCD tools
Xinquan Zhang et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2011)
A study on the effect of tool nose radius in ultrasonic elliptical vibration cutting of tungsten carbide
Chandra Nath et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
Ultra-precision surface finish of NAK80 mould tool steel using sequential ball burnishing and ball polishing processes
F. J. Shiou et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2008)
Review of vibration-assisted machining
D. E. Brehl et al.
PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY (2008)
Tool wear when turning hardened AISI 4340 with coated PCBN tools using finishing cutting conditions
Reginaldo T. Coelho et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2007)
Design optimization of cutting parameters when turning hardened AISI 4140 steel (63 HRC) with Al2O3+TiCN mixed ceramic tool
Ersan Aslan et al.
MATERIALS & DESIGN (2007)
Analysis of chatter suppression in vibration cutting
M Xiao et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2002)
分享论文
