Effect of sintering temperature on microstructure and properties of graphene nanoplatelets reinforced TC21 composites prepared by spark plasma sintering

Graphene nanoplates (GNPs) have been adopted in titanium matrix composite manufacturing and design due to its superior mechanical properties. In this study, Graphene nanoplates reinforced Ti-6Al-2Sn-2Zr-3Mo-1Cr-2Nb-Si alloys (named as GNPs/TC21 composites) were prepared by using spark plasma sintering (SPS), and the effects of sintering temperature on the microstructure, mechanical and wear properties of GNPs/TC21 composites were systematically investigated. The results indicate that the sintering tempera-tures show a great influence on the interfacial structure. With the increase of sintering temperature from 850 degrees C to 1050 degrees C, the interfacial microstructures exhibit three morphographies: (1) The original TC21 particles coated with GNPs (850 degrees C); (2) A special TiC@GNPs band (900 degrees C-100 0 degrees C); (3) A discontinuous network structure wrapped by TiC particles/plates (1050 degrees C). Mechanical and tribological properties of the GNPs/TC21 composites were investigated at room temperature. The optimal SPS temperature was 1000 degrees C, at which the GNPs/TC21 composites show the best comprehensive mechanical properties i.e. the ultimate tensile strength and yield strength are 1167 MPa and 1041 MPa, the friction coefficient is 0.16275 and the wear loss is 0.0179 g. The improvement of mechanical properties can be attributed to the synergistic strengthening of the load transfer effect of TiC@GNPs bands and the pinning effect of TiC particles/plates. The excellent wear resistance is mainly attributed to the pinning of TiC particles on the surrounding metal matrix and the strengthening and lubrication of GNPs. (c) 2021 Elsevier B.V. All rights reserved.

Automated summary

Graphene nanoplates are widely used in titanium matrix composite manufacturing due to their superior mechanical properties. The study showed that sintering temperature greatly influences the interfacial structures and comprehensive mechanical properties of the composites, with 1000 degrees Celsius being the optimal SPS temperature.