相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Influence of surface conditions and specimen orientation on high cycle fatigue properties of Inconel 718 prepared by laser powder bed fusion
David B. Witkin et al.
INTERNATIONAL JOURNAL OF FATIGUE (2020)
Fracture-Mechanical Assessment of the Effect of Defects on the Fatigue Lifetime and Limit in Cast and Additively Manufactured Aluminum-Silicon Alloys from HCF to VHCF Regime
Jochen Tenkamp et al.
METALS (2020)
Fatigue strength assessment of as built AlSi10Mg manufactured by SLM with different build orientations
S. Beretta et al.
INTERNATIONAL JOURNAL OF FATIGUE (2020)
Room and elevated temperature fatigue crack propagation behavior of Inconel 718 alloy fabricated by laser powder bed fusion
Sumin Kim et al.
INTERNATIONAL JOURNAL OF FATIGUE (2020)
The influence of additive manufacturing processing parameters on surface roughness and fatigue life
Joy Gockel et al.
INTERNATIONAL JOURNAL OF FATIGUE (2019)
A new FE post-processor for probabilistic fatigue assessment in the presence of defects and its application to AM parts
S. Romano et al.
INTERNATIONAL JOURNAL OF FATIGUE (2019)
Primary Processing Parameters, Porosity Production, and Fatigue Prediction for Additively Manufactured Alloy 718
Luke Sheridan et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2019)
Effect of build orientation on the fatigue properties of as-built Electron Beam Melted Ti-6Al-4V alloy
Theo Persenot et al.
INTERNATIONAL JOURNAL OF FATIGUE (2019)
Fatigue properties of AlSi10Mg obtained by additive manufacturing: Defect-based modelling and prediction of fatigue strength
S. Romano et al.
ENGINEERING FRACTURE MECHANICS (2018)
Short-crack thresholds and propagation in an AISI4340steel under the effect of SP residual stresses
L. Patriarca et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2018)
Relating porosity to fatigue failure in additively manufactured alloy 718
Luke Sheridan et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Defect analysis and fatigue design basis for Ni-based superalloy 718 manufactured by selective laser melting
Yoichi Yamashita et al.
INTERNATIONAL JOURNAL OF FATIGUE (2018)
Influence of defects and as-built surface roughness on fatigue properties of additively manufactured Alloy 718
Arun Ramanathan Balachandramurthi et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Influence of porosity on the fatigue behaviour of additively fabricated TA6V alloys
Viet-Duc Le et al.
12TH INTERNATIONAL FATIGUE CONGRESS (FATIGUE 2018) (2018)
A comparison of fatigue strength sensitivity to defects for materials manufactured by AM or traditional processes
S. Beretta et al.
INTERNATIONAL JOURNAL OF FATIGUE (2017)
A simple approximate expression for finite life fatigue behaviour in the presence of 'crack-like' or 'blunt' notches
M. Ciavarella
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2012)
Modelling of fatigue thresholds for small cracks in a mild steel by Strip-Yield model
S. Beretta et al.
ENGINEERING FRACTURE MECHANICS (2009)
On the possible generalizations of the Kitagawa-Takahashi diagram and of the El Haddad equation to finite life
M. Ciavarella et al.
INTERNATIONAL JOURNAL OF FATIGUE (2006)
分享论文
