期刊
CERAMICS INTERNATIONAL
卷 47, 期 16, 页码 22424-22434出版社
ELSEVIER SCI LTD
DOI: 10.1016/j.ceramint.2021.04.252
关键词
Joining; Phase diagram; Evaporation; Isothermal solidification; Electron microscopy
资金
- JSPS KAKENHI [JP18K04726]
- Japan Keirin Autorace foundation
The research showed that by using different contents of Mg in Si-Mg fillers, Si3N4/Si3N4 joints with different strengths can be achieved. When the Mg content exceeds 37%, the densification/thinning of the Si layer will enhance the tensile strength of the joint, and network-like structures of MgO can be observed in high Mg content situations.
Silicon-nitride (Si3N4) components were joined under vacuum at 1100 degrees C for 10 min using Si-Mg composite fillers with Mg contents (XMg) that ranged from 0 at.% to 59 at.%. The Si3N4/Si3N4 joints were fabricated via Si layer formation at the joint interface; the molten Si-Mg liquid was transformed into a solid Si layer after Mgevaporation-induced isothermal solidification. The joint tensile strength at room temperature increased considerably when XMg exceeded the liquidus composition of 37 at.% because of the enhanced densification/ thinning of the Si layer. In these cases, some Mg atoms reacted with Si3N4 to form a fine-grained MgSiN2-based layer, whereas relatively large ( 0.1 mu m) and smaller MgO precipitates (<10 nm) were observed in the Si layer. At a high XMg, the MgO precipitates were arranged in a network-like structure, which improved the fracture strength of the Si layer. The joints with a high strength at room temperature were examined using a three-point bending test at 1200 degrees C in air and endured a maximum fracture stress of -200 MPa, which confirmed their potential for use in oxidizing atmospheres at least 100 degrees C above the bonding temperature.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据