4.6 Article

Investigation on the Performance Enhancement and Emission Reduction of a Biodiesel Fueled Diesel Engine Based on an Improved Entire Diesel Engine Simulation Model

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Thermodynamics

Investigation on H2/air combustion with C3H8 addition in the combustor with part/full porous medium

Qingguo Peng et al.

Summary: The study examined the effects of different propane blended ratios on premixed H-2/air combustion in micro thermophotovoltaic systems, finding that adding 5% propane can improve combustion characteristics and energy conversion efficiency. The formation of heat recirculation in the combustor was noted to enhance thermal performance and achieve higher flame temperature and radiation temperature.

ENERGY CONVERSION AND MANAGEMENT (2021)

Article Thermodynamics

Comparative study on the thermodynamic and economic performance of novel absorption power cycles driven by the waste heat from a supercritical CO2 cycle

Feng Zhang et al.

Summary: This study investigates the performance improvement of the recompression supercritical carbon dioxide (sCO(2)) power cycle by integrating with two novel absorption power cycles (APC). Comparative study and optimization analysis show that all APC subsystems can enhance the stand-alone sCO(2) system performance and the proposed sCO(2)/APC systems further improve the overall performance of the original sCO(2)/APC system.

ENERGY CONVERSION AND MANAGEMENT (2021)

Article Energy & Fuels

Numerical simulation study on soot continuous regeneration combustion model of diesel particulate filter under exhaust gas heavy load

Xiaohuan Zhao et al.

Summary: The study proposes a 3D soot continuous regeneration combustion model under exhaust gas heavy load using UDF function in FLUENT software, investigating 3 different models for simulation study with EDC model showing advantages in terms of turbulent kinetic energy and temperature. The results suggest that EDC model is more suitable for stable laminar flow state conditions.
Article Energy & Fuels

Investigations on the soot combustion performance enhancement of an improved catalytic gasoline particulate filter regeneration system under different electric heating powers

Yong Xie et al.

Summary: This study proposes an improved catalytic gasoline engine particulate filter regeneration system (C-GPFs) with electric heating to control pollutant emissions during cold start, and provides a solution to reduce energy consumption by studying combustion performance and critical filter structure parameters.
Review Green & Sustainable Science & Technology

A review of studies using hydrocarbon adsorption material for reducing hydrocarbon emissions from cold start of gasoline engine

Dandan Han et al.

Summary: The article summarizes measures for reducing hydrocarbon emissions during cold start of gasoline engines, including pre-treatment and after-treatment approaches, as well as the use of HC adsorption technology.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2021)

Article Thermodynamics

Effects of adding cyclohexane, n-hexane, ethanol, and 2,5-dimethylfuran to fuel on soot formation in laminar coflow n-heptane/iso-octane diffusion flame

Huaqiang Chu et al.

Summary: The study investigates the effects of oxygen-free and oxygen-containing aliphatic and aromatic hydrocarbons on soot formation, finding that soot formed in flames doped with ethanol has a unique structure, while other doped flames are susceptible to oxidation by free radicals.

COMBUSTION AND FLAME (2021)

Article Energy & Fuels

Effects analysis on soot combustion performance enhancement of an improved catalytic gasoline particulate filter regeneration system with electric heating

Yong Xie et al.

Summary: This study identified the direction to improve soot combustion performance at low temperatures by increasing exhaust temperature and oxygen concentration, while decreasing exhaust flow rate and nitrogen oxide concentration, resulting in reduced electric energy consumption.
Article Energy & Fuels

The effects of Fe2O3 based DOC and SCR catalyst on the combustion and emission characteristics of a diesel engine fueled with biodiesel

Zhiqing Zhang et al.

Summary: The paper investigates the effects of Fe2O3 based diesel oxidation catalyst and selective catalytic reduction catalyst on engine characteristics of diesel engine fueled with biodiesels. The results show that biodiesel fuel reduces CO and HC emissions, but increases NOx emissions slightly.
Article Energy & Fuels

A realistic skeletal mechanism for the oxidation of biodiesel surrogate composed of long carbon chain and polyunsaturated compounds

Gang Wu et al.

Summary: The study developed a mechanism with three parts for simulating the combustion of biodiesel in compression ignition engine, including simplified fuel-related, ester group-related, and detailed core sub-mechanisms. Validation results showed that the predicted outcomes of the mechanism were in agreement with experimental information, verifying its effectiveness and accuracy.
Article Green & Sustainable Science & Technology

Effects of different poses and wind speeds on wind-induced vibration characteristics of a dish solar concentrator system

Hongyan Zuo et al.

Summary: The study investigated the anti-vibration characteristics of a DSC system under wind-induced vibration, revealing that natural frequencies mainly range from 0.8396 to 4.135 Hz at different wind speeds. The maximum deformation is 2.5055 mm, indicating the need to check local stiffness in the design process. Moreover, the maximum stress of the DSC system is below the yield limit of carbon steel (Q345), ensuring good safety during normal working conditions.

RENEWABLE ENERGY (2021)

Article Environmental Sciences

On-road emission measurements of reactive nitrogen compounds from heavy-duty diesel trucks in China

Liqiang He et al.

ENVIRONMENTAL POLLUTION (2020)

Article Materials Science, Multidisciplinary

Morphology control of manganese-based catalysts for low-temperature selective catalytic reduction of NOx

Haoxi Jiang et al.

MATERIALS LETTERS (2018)

Review Green & Sustainable Science & Technology

Effect of different technologies on combustion and emissions of the diesel engine fueled with biodiesel: A review

Jiaqiang E et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2017)

Review Green & Sustainable Science & Technology

Combustion noise radiation during dynamic diesel engine operation including effects of various biofuel blends: A review

Evangelos G. Giakoumis et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2016)

Article Thermodynamics

Mitigation of premixed flame-sustained thermoacoustic oscillations using an electrical heater

Dan Zhao et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2015)

Proceedings Paper Thermodynamics

A Critical Analysis on the Lubrication Circuit of a non-road Diesel Engine by Adopting a 3D and 1D Approaches

Emma Frosina et al.

69TH CONFERENCE OF THE ITALIAN THERMAL ENGINEERING ASSOCIATION, ATI 2014 (2015)

Article Engineering, Environmental

Effect of Fuel Injection Pressure on a Heavy-Duty Diesel Engine Nonvolatile Particle Emission

Tero Lahde et al.

ENVIRONMENTAL SCIENCE & TECHNOLOGY (2011)

Article Energy & Fuels

Coupled dynamic-multidimensional modelling of free-piston engine combustion

R. Mikalsen et al.

APPLIED ENERGY (2009)

Article Engineering, Multidisciplinary

Nonlinear modelling and control of a common rail injection system for diesel engines

Paolo Lino et al.

APPLIED MATHEMATICAL MODELLING (2007)

Article Energy & Fuels

Observer design for downsized gasoline engine control using 1D engine simulation

A Albrecht et al.

OIL & GAS SCIENCE AND TECHNOLOGY-REVUE D IFP ENERGIES NOUVELLES (2006)