Temporal Variation of Road Dust Load and Its Size Distribution-a Comparative Study of a Porous and a Dense Pavement

Resuspension of road dust contributes to air quality issues with resulting health impacts. Limited studies imply that porous pavements can initially mitigate PM10 emissions by acting as a dust trap, but the abrasion wear generates road dust and thus accelerates the clogging processes. In addition, knowledge regarding the impact of pavement types on road dust load dynamics is limited. Road traffic noise can be mitigated using porous pavements, but the use of studded tyres increases the abrasion wear of the pavement as well as increasing the noise emission. Due to this durability problem, porous pavements are rarely used in the Nordic countries where, instead, dense pavements which are abrasion resistant are more common. Linkoping municipality, in Sweden, constructed a porous pavement to mitigate road traffic noise. This led to the opportunity to investigate the temporal variation of the dust load dynamics and inherent size distributions over the winter and spring in comparison to those of an adjacent dense pavement. Results, when using the wet dust sampler (WDS) method, showed similar dust load dynamics for the dense and porous pavements. The results were also compared to previous studies using the same method on different dense pavements in Stockholm, Sweden. All locations showed a seasonal variation with higher dust loads during winter and early spring and declining loads towards summer. The size distributions were more complex for the wheel tracks at the porous pavement, having primarily properties of a mixture model compared to the simple size distributions for the dense pavement. On the other hand, the dust load and size distribution were more similar between the porous and dense pavements regarding loads and shapes, indicating a less pronounced but similar behaviour between the surfaces outside of the wheel tracks.