Exploring the scale-dependent permeability of fractured andesite

Extension fractures in volcanic systems exist on all scales, from microscopic fractures to large fissures. They play a fundamental role in the movement of fluids and distribution of pore pressure, and therefore exert considerable influence over volcanic eruption recurrence. We present here laboratory permeability measurements for porous (porosity = 0.03-0.6) andesites before (i.e., intact) and after failure in tension (i.e., the samples host a throughgoing tensile fracture). The permeability of the intact andesites increases with increasing porosity, from 2 x 10(-17) to 5 x 10(-11) m(2). Following fracture formation, the permeability of the samples (the equivalent permeability) falls within a narrow range, 2-6 x 10(-11) m(2), regardless of their initial porosity. However, laboratory measurements on fractured samples likely overestimate the equivalent permeability due to the inherent scale-dependence of permeability. To explore this scale dependence, we first determined the permeability of the tensile fractures using a two-dimensional model that considers flow in parallel layers. Our calculations highlight that tensile fractures in low porosity samples are more permeable (as high as 3.5 x 10(-9) m(2)) than those in high-porosity samples (as low as 4.1 x 10(-10) m2), a difference that can be explained by an increase in fracture tortuosity with porosity. We then use our fracture permeability data to model the equivalent permeability of fractured rock (with different host rock permeabilities, from 10(-17) to 10(-11) m(2)) with increasing lengthscale. We highlight that our modelling approach can be used to estimate the equivalent pertheability of numerous scenarios at andesitic stratovolcanoes in which the fracture density and width and host rock porosity or permeability are known. The model shows that the equivalent permeability of fractured andesite depends heavily on the initial host rock permeability and the scale of interest. At a given lengthscale, the equivalent permeability of high-permeability rock (10(-12) to 10(-11) m(2)) is essentially unaffected by the presence of numerous tensile fractures. By contrast, a single tensile fracture increases the equivalent permeability of low-permeability rock (<10(-15) m(2)) by many orders of magnitude. We also find that fractured, low-permeability rock (e.g., 10(-17) m(2)) can have an equivalent permeability higher than that of similarly fractured rock with higher host rock permeability (e.g., 10(-15) m(2)) due to the low-tortuosity of fractures in low-porosity andesite. Our modelling therefore outlines the importance of fractures in low-porosity, low-permeability volcanic systems. While our laboratory measurements show that, regardless of the initial porosity, the equivalent permeability of fractured rock on the laboratory scale is 2-6 x 10-11 m2, the equivalent permeability of low-permeability rock is significantly reduced as the scale of interest is increased. Therefore, due to the scale-dependence of permeability, laboratory measurements on pristine, low-permeability rocks significantly underestimate the equivalent permeability of fractured volcanic rock. Further, measurements on fractured rock samples can significantly overestimate the equivalent permeability. As a result, care must be taken when selecting samples in the field and when using laboratory data in volcano outgassing models. The data and modelling presented herein provide insight into the scale-dependence of the permeability of fractured volcanic rock, a prerequisite for understanding outgassing at active volcanoes. (C) 2016 Elsevier B.V. All rights reserved.