相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。A powder-metallurgy-based fabrication route towards achieving high tensile strength with ultra-high ductility in high-entropy alloy
Peyman Asghari-Rad et al.
SCRIPTA MATERIALIA (2021)
Effect of Initial Grain Size on Deformation Mechanism during High-Pressure Torsion in V10Cr15Mn5Fe35Co10Ni25 High-Entropy Alloy
Peyman Asghari-Rad et al.
ADVANCED ENGINEERING MATERIALS (2020)
Development and Microstructural Characterization of a New Wrought High Entropy Superalloy
Ahad Shafiee et al.
METALS AND MATERIALS INTERNATIONAL (2020)
Microstructure Stability and Its Influence on the Mechanical Properties of CrMnFeCoNiAl0.25High Entropy Alloy
Lijing Lin et al.
METALS AND MATERIALS INTERNATIONAL (2020)
The tension-compression asymmetry of martensite phase transformation in a metastable Fe40Co20Cr20Mn10Ni10 high-entropy alloy
Xinglong An et al.
SCIENCE CHINA-MATERIALS (2020)
Plastic Deformation Behavior of 40Fe-25Ni-15Cr-10Co-10V High-Entropy Alloy for Cryogenic Applications
Min Ji Jang et al.
METALS AND MATERIALS INTERNATIONAL (2019)
Deformation-driven bidirectional transformation promotes bulk nanostructure formation in a metastable interstitial high entropy alloy
Jing Su et al.
ACTA MATERIALIA (2019)
Fully Recrystallized Al0.5CoCrFeNi High-Entropy Alloy Strengthened by Nanoscale Precipitates
Haoxue Yang et al.
METALS AND MATERIALS INTERNATIONAL (2019)
Hot Deformation Behavior of V Micro-Alloyed TWIP Steel During Hot Compression
Hojun Gwon et al.
METALS AND MATERIALS INTERNATIONAL (2019)
Enhancing strength and strain hardenability via deformation twinning in fcc-based high entropy alloys reinforced with intermetallic compounds
Deep Choudhuri et al.
ACTA MATERIALIA (2019)
Dynamic shear deformation of a CrCoNi medium-entropy alloy with heterogeneous grain structures
Yan Ma et al.
ACTA MATERIALIA (2018)
Twinning in metastable high-entropy alloys
Shuo Huang et al.
NATURE COMMUNICATIONS (2018)
Cryogenic-deformation-induced phase transformation in an FeCoCrNi high-entropy alloy
Qingyun Lin et al.
MATERIALS RESEARCH LETTERS (2018)
Structural evolutions of metallic materials processed by severe plastic deformation
Yang Cao et al.
MATERIALS SCIENCE & ENGINEERING R-REPORTS (2018)
Annealing-induced hardening in high-pressure torsion processed CoCrNi medium entropy alloy
S. Praveen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Ultra-high tensile strength nanocrystalline CoCrNi equi-atomic medium entropy alloy processed by high-pressure torsion
S. Praveen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Effect of stacking faults on the ductility of Fe-18Mn-1.5Al-0.6C twinning-induced plasticity steel at low temperatures
Joon Yoo et al.
SCRIPTA MATERIALIA (2017)
Metastable high-entropy dual-phase alloys overcome the strength-ductility trade-off
Zhiming Li et al.
NATURE (2016)
Exceptional damage-tolerance of a medium-entropy alloy CrCoNi at cryogenic temperatures
Bernd Gludovatz et al.
NATURE COMMUNICATIONS (2016)
Design of a twinning-induced plasticity high entropy alloy
Y. Deng et al.
ACTA MATERIALIA (2015)
Significance of grain boundaries and stacking faults on hydrogen storage properties of Mg2Ni intermetallics processed by high-pressure torsion
Toshifumi Hongo et al.
ACTA MATERIALIA (2015)
Formation of epsilon martensite by high-pressure torsion in a TRIP steel
Roberto B. Figueiredo et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Martensitic Phase Transformation and Deformation Behavior of Fe-Mn-C-Al Twinning-Induced Plasticity Steel during High-Pressure Torsion
Kun Yan et al.
ADVANCED ENGINEERING MATERIALS (2014)
Microstructure and mechanical response of single-crystalline high-manganese austenitic steels under high-pressure torsion: The effect of stacking-fault energy
E. G. Astafurova et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
A fracture-resistant high-entropy alloy for cryogenic applications
Bernd Gludovatz et al.
SCIENCE (2014)
The critical role of grain orientation and applied stress in nanoscale twinning
Rodney J. McCabe et al.
NATURE COMMUNICATIONS (2014)
Mechanism of activation of TiFe intermetallics for hydrogen storage by severe plastic deformation using high-pressure torsion
Kaveh Edalati et al.
APPLIED PHYSICS LETTERS (2013)
Applied stress controls the production of nano-twins in coarse-grained metals
Y. Cao et al.
APPLIED PHYSICS LETTERS (2012)
Processing a twinning-induced plasticity steel by high-pressure torsion
Mariana S. Matoso et al.
SCRIPTA MATERIALIA (2012)
The role of stacking faults and twin boundaries in grain refinement of a Cu-Zn alloy processed by high-pressure torsion
Y. B. Wang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
The effect of grain size and grain orientation on deformation twinning in a Fe-22 wt.% Mn-0.6 wt.% C TWIP steel
I. Gutierrez-Urrutia et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
Derivation and Variation in Composition-Dependent Stacking Fault Energy Maps Based on Subregular Solution Model in High-Manganese Steels
A. Saeed-Akbari et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2009)
Using high-pressure torsion for metal processing: Fundamentals and applications
Alexander P. Zhilyaev et al.
PROGRESS IN MATERIALS SCIENCE (2008)
分享论文
