期刊
JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING
卷 196, 期 -, 页码 -出版社
ELSEVIER
DOI: 10.1016/j.petrol.2020.107704
关键词
Agglomeration; Nanofluid; Oil recovery; Rheology; Salt; Surfactant; Viscosity
资金
- Rajiv Gandhi Institute of Petroleum Technology, Jais, India
Single-step silica nanofluids were found to destabilize at higher temperatures and in the presence of salt, but showed stability within a pH range of 8-10. The addition of anionic surfactant improved nanofluid stability, although high surfactant concentrations resulted in increased agglomeration. Using surfactant treated single-step silica nanofluids may provide better results for oil recovery applications compared to conventional nanofluids.
Single-step nanofluids have shown better stability and size control properties than conventional two-step nanofluids under similar conditions. However, for wide-spread oilfield acceptance, there is a need to investigate the role of oilfield conditions viz., temperature, salt and pH on stability of single-step nanofluids. Thus, in this study, single-step silica nanofluids were synthesized in base fluid (1000 ppm polyacrylamide, PAM) and their stability was investigated using methods such as dynamic light scattering (DLS) and rheological analysis to establish their viability as suitable enhanced oil recovery (EOR) agents. PAM is a widely used oilfield practically applicable polymer. Primarily, the single-step silica nanofluids were found to destabilize at higher temperatures (>= 90 degrees C) due to thermal stability issues of PAM at high temperatures. This was also understood by PAM rheology. The inclusion of salt reduced the stability of nanofluids due to the suppression of inter-particle repulsive forces. The variation in pH also influenced nanofluid stability and pH range of 8-10 was observed for the stable behavior of nanofluids. The addition of an anionic surfactant (SDS) improved nanofluid stability by reducing salt-induced NP agglomeration; increasing surfactant concentration initially improved nanofluid resistance to salt induced agglomeration and at high surfactant concentrations, the nanofluids exhibited greater NP agglomeration even in the absence of salt. The oil recovery results also showed that surfactant use in the synthesis of silica nanofluid for oil recovery applications may provide better results than sole silica nanofluid. Based on the observations, surfactant treated single-step silica nanofluid use was found favorable for oilfield practices where conventional nanofluids may show challenges.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据