相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Elucidating the dual role of grain boundaries as dislocation sources and obstacles and its impact on toughness and brittle-to-ductile transition
Jens Reiser et al.
SCIENTIFIC REPORTS (2020)
Spatially dependent kinetics of helium in tungsten under fusion conditions
V. Shah et al.
JOURNAL OF NUCLEAR MATERIALS (2020)
Numerical investigation of the brittle-to-ductile transition temperature of rolled high-purity tungsten
M. A. Oude Vrielink et al.
MECHANICS OF MATERIALS (2020)
Experimental investigation of the microstructural changes of tungsten monoblocks exposed to pulsed high heat loads
V Shah et al.
NUCLEAR MATERIALS AND ENERGY (2020)
Progress of the EU activities for the ITER Divertor Inner Vertical Target procurement
Bruno Riccardi et al.
FUSION ENGINEERING AND DESIGN (2019)
Ductile to brittle transition in ITER specification tungsten assessed by combined fracture toughness and bending tests analysis
Chao Yin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Temperature dependence of retarded recrystallisation in helium plasma-exposed tungsten
K. Song et al.
NUCLEAR FUSION (2019)
An investigation of the microstructure and ductility of annealed cold-rolled tungsten
Chai Ren et al.
ACTA MATERIALIA (2019)
Impact of tungsten recrystallization on ITER-like components for lifetime estimation
A. Durif et al.
FUSION ENGINEERING AND DESIGN (2019)
The brittle-to-ductile transition in cold rolled tungsten plates: Impact of crystallographic texture, grain size and dislocation density on the transition temperature
Carsten Bonnekoh et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2019)
Effects of neutron irradiation on the brittle to ductile transition in single crystal tungsten
R. G. Abernethy et al.
JOURNAL OF NUCLEAR MATERIALS (2019)
Effect of anisotropic microstructure of ODS steels on small punch test results
E. Altstadt et al.
THEORETICAL AND APPLIED FRACTURE MECHANICS (2019)
Design optimization of the ITER tungsten divertor vertical targets
T. Hirai et al.
FUSION ENGINEERING AND DESIGN (2018)
Cold rolled tungsten (W) plates and foils: Evolution of the tensile properties and their indication towards deformation mechanisms
Simon Bonk et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2018)
The brittle-to-ductile transition in cold rolled tungsten: On the decrease of the brittle-to-ductile transition by 600 K to-65 °C
Carsten Bonnekoh et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2018)
Retarded recrystallization of helium-exposed tungsten
Wangguo Guo et al.
NUCLEAR FUSION (2018)
The influence of plasma-surface interaction on the performance of tungsten at the ITER divertor vertical targets
G. De Temmerman et al.
PLASMA PHYSICS AND CONTROLLED FUSION (2018)
Degradation of tungsten monoblock divertor under cyclic high heat flux loading
Shuhei Nogami et al.
FUSION ENGINEERING AND DESIGN (2017)
Fracture modes of ITER tungsten divertor monoblock under stationary thermal loads
S. Panayotis et al.
FUSION ENGINEERING AND DESIGN (2017)
On the determination of the ductile to brittle transition temperature from small punch tests on Grade 91 ferritic-martensitic steel
M. Bruchhausen et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2017)
Development of advanced high heat flux and plasma-facing materials
Ch. Linsmeier et al.
NUCLEAR FUSION (2017)
Material properties and their influence on the behaviour of tungsten as plasma facing material
M. Wirtz et al.
NUCLEAR FUSION (2017)
The mobility of small vacancy/helium complexes in tungsten and its impact on retention in fusion-relevant conditions
Danny Perez et al.
SCIENTIFIC REPORTS (2017)
Self-castellation of tungsten monoblock under high heat flux loading and impact of material properties
S. Panayotis et al.
NUCLEAR MATERIALS AND ENERGY (2017)
Helium-Ion-Implantation in Tungsten: Progress towards a Coherent Understanding of the Damage Formed and its Effects on Properties
F. Hofmann et al.
2016 IUTAM SYMPOSIUM ON NANOSCALE PHYSICAL MECHANICS (2017)
Ductilisation of tungsten (W): On the shift of the brittle-to-ductile transition (BDT) to lower temperatures through cold rolling
Jens Reiser et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2016)
Microstructure and tensile properties of tungsten at elevated temperatures
Tielong Shen et al.
JOURNAL OF NUCLEAR MATERIALS (2016)
Surface damage and structure evolution of recrystallized tungsten exposed to ELM-like transient loads
Y. Yuan et al.
NUCLEAR FUSION (2016)
Thermal shock tests to qualify different tungsten grades as plasma facing material
M. Wirtz et al.
PHYSICA SCRIPTA (2016)
Charecterization of ITER tungsten qualification mock-ups exposed to high cyclic thermal loads
Gerald Pintsuk et al.
FUSION ENGINEERING AND DESIGN (2015)
High heat flux testing of EU tungsten monoblock mock-ups for the ITER divertor
P. Gavila et al.
FUSION ENGINEERING AND DESIGN (2015)
Engineering challenges and development of the ITER Blanket System and Divertor
Mario Merola et al.
FUSION ENGINEERING AND DESIGN (2015)
The nature of the brittle-to-ductile transition of ultra fine grained tungsten (W) foil
Andre A. N. Nemeth et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2015)
Segregation of alloying atoms at a tilt symmetric grain boundary in tungsten and their strengthening and embrittling effects
Li Zhi-Wu et al.
CHINESE PHYSICS B (2014)
TUNGSTEN MELT LOSSES UNDER QSPA KH-50 PLASMA EXPOSURES SIMULATING ITER ELMs AND DISRUPTIONS
I. E. Garkusha et al.
FUSION SCIENCE AND TECHNOLOGY (2014)
Experimental simulation of materials degradation of plasma-facing components using lasers
N. Farid et al.
NUCLEAR FUSION (2014)
An examination of nickel doping effect on the mechanical strength of a tungsten grain boundary
Hongsuk Lee et al.
COMPUTATIONAL MATERIALS SCIENCE (2013)
Thermal shock response of deformed and recrystallised tungsten
M. Wirtz et al.
FUSION ENGINEERING AND DESIGN (2013)
Qualification and post-mortem characterization of tungsten mock-ups exposed to cyclic high heat flux loading
G. Pintsuk et al.
FUSION ENGINEERING AND DESIGN (2013)
ITER tungsten divertor design development and qualification program
T. Hirai et al.
FUSION ENGINEERING AND DESIGN (2013)
Comparison of thermal shock damages induced by different simulation methods on tungsten
M. Wirtz et al.
JOURNAL OF NUCLEAR MATERIALS (2013)
Impact of microstructure on the plasma performance of industrial and high-end tungsten grades
G. Pintsuk et al.
JOURNAL OF NUCLEAR MATERIALS (2013)
A full tungsten divertor for ITER: Physics issues and design status
R. A. Pitts et al.
JOURNAL OF NUCLEAR MATERIALS (2013)
Fatigue damage assessment of alternator fans by EBSD
J. -B. Vogt et al.
FATIGUE DESIGN 2013, INTERNATIONAL CONFERENCE PROCEEDINGS (2013)
Tungsten foil laminate for structural divertor applications - Analyses and characterisation of tungsten foil
Jens Reiser et al.
JOURNAL OF NUCLEAR MATERIALS (2012)
Effects of transition metals on the grain boundary cohesion in tungsten
Wahyu Setyawan et al.
SCRIPTA MATERIALIA (2012)
Deuterium retention in tungsten exposed to low-energy pure and helium-seeded deuterium plasmas
O. V. Ogorodnikova et al.
JOURNAL OF APPLIED PHYSICS (2011)
Property change mechanism in tungsten under neutron irradiation in various reactors
Akira Hasegawa et al.
JOURNAL OF NUCLEAR MATERIALS (2011)
Loading rate dependence of the fracture toughness of polycrystalline tungsten
Daniel Rupp et al.
JOURNAL OF NUCLEAR MATERIALS (2011)
Tungsten as material for plasma-facing components in fusion devices
V. Philipps
JOURNAL OF NUCLEAR MATERIALS (2011)
A Review of Strain Analysis Using Electron Backscatter Diffraction
Stuart I. Wright et al.
MICROSCOPY AND MICROANALYSIS (2011)
Performance of different tungsten grades under transient thermal loads
J. Linke et al.
NUCLEAR FUSION (2011)
Modeling size effects on fracture toughness by dislocation dynamics
X. H. Zeng et al.
ACTA MATERIALIA (2010)
High temperature fracture experiments on tungsten-rhenium alloys
Stefan Wurster et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2010)
Effect of Rhenium on the Dislocation Core Structure in Tungsten
Lorenz Romaner et al.
PHYSICAL REVIEW LETTERS (2010)
Cracking failure study of ITER-reference tungsten grade under single pulse thermal shock loads at elevated temperatures
T. Hirai et al.
JOURNAL OF NUCLEAR MATERIALS (2009)
The mechanical properties of tungsten grown by chemical vapour deposition
J. D. Murphy et al.
JOURNAL OF NUCLEAR MATERIALS (2009)
Enhanced erosion of tungsten plasma-facing components subject to simultaneous heat pulses and deuterium plasma
K. R. Umstadter et al.
JOURNAL OF NUCLEAR MATERIALS (2009)
Cube texture in hot-rolled aluminum alloy 1050 (AA1050) - nucleation and growth behavior
Mohammed H. Alvi et al.
ACTA MATERIALIA (2008)
Processing induced size effects in plastic yielding upon miniaturisation
P. J. M. Janssen et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2008)
Effect of low-temperature rolling on the tensile behavior of commercially pure tungsten
Q. Wei et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
Thin intergranular films and solid-state activated sintering in nickel-doped tungsten
Vivek K. Gupta et al.
ACTA MATERIALIA (2007)
Strain-rate dependence of the brittle-to-ductile transition temperature in tungsten
A. Giannattasio et al.
PHILOSOPHICAL MAGAZINE (2007)
High heat flux performance of plasma facing materials and components under service conditions in future fusion reactors
J Linke
FUSION SCIENCE AND TECHNOLOGY (2006)
Plasma facing and high heat flux materials - needs for ITER and beyond
H Bolt et al.
JOURNAL OF NUCLEAR MATERIALS (2002)
Operating temperature windows for fusion reactor structural materials
SJ Zinkle et al.
FUSION ENGINEERING AND DESIGN (2000)
分享论文
