Evaluation of low fidelity and CFD methods for the aerodynamic performance of a small propeller

The increasing use of unmanned aerial vehicles and micro air vehicles creates a strong demand for the accurate aerodynamic performance of small-diameters fixed-pitch propellers. The techniques range from low-fidelity to high-fidelity methods. Among the low-fidelity techniques, there is the blade element momentum theory (BEMT). Computational fluid dynamics (CFD) is categorized as a high-fidelity method. This study aims to employ these methods for the analysis of an APC propeller 14 x 7e. Geometric modeling was performed in a 3D scanner and simulations via BEMT and CFD. Analyses using the BEMT model were conducted with two formulations. The first one considered a linear lift coefficient up to the stall limits, without specifying the post-stall lift coefficients. The second one incorporates three-dimensional flow equilibrium effects, and best represents the post-stall conditions. In the CFD models, two approaches for the compatibility of the rotating and stationary domains were evaluated, the stationary frozen rotor (FR) and the transient arbitrary mesh interface (AMI). The kw SST turbulence model was employed. To investigate the influence of the transition laminar-turbulent boundary layer, the Gamma Theta transitional model was also considered. In the comparison of the results with the experimental tests, it was observed that the appropriate choice of analysis method had a strong relationship with the Reynolds number. For low advanced ratio velocities, the best results were obtained with the BEMT models. BEMT linear model overpredicted the power and efficiency for high advance ratio, while BEMT with tridimensional flow equilibrium presented consistent results with a low computational cost. On the other hand, the CFD-AMI model shows better results for higher advanced ratio velocities but is computationally more expensive. The CFD-FR model maintains a constant pattern of error that, in the analysis of efficiency, did not compromise the results. (C) 2020 Elsevier Masson SAS. All rights reserved.

Automated summary

The increasing use of unmanned aerial vehicles and micro air vehicles creates a strong demand for the accurate aerodynamic performance of small-diameters fixed-pitch propellers, which can be analyzed using both low-fidelity methods like blade element momentum theory (BEMT) and high-fidelity methods like computational fluid dynamics (CFD). This study aims to employ these methods to analyze an APC propeller, highlighting the relationship between analysis method choice and Reynolds number, as well as the performance differences at different advance ratio velocities.