相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。Carbon-Coating Layers on Boron Generated High Critical Current Density in MgB2 Superconductor
Haobo Liu et al.
ACS APPLIED MATERIALS & INTERFACES (2020)
Tailored joint fabrication process derived ultra-low resistance MgB2 superconducting joint
Dipak Patel et al.
SCRIPTA MATERIALIA (2020)
Interplay between cold densification and malic acid addition (C4H6O5) for the fabrication of near-isotropic MgB2 conductors for magnet application
Md Shahriar A. Hossain et al.
JOURNAL OF MAGNESIUM AND ALLOYS (2020)
MgB2 for MRI applications: dual sintering induced performance variations in in situ and IMD processed MgB2 conductors
Dipak Patel et al.
JOURNAL OF MATERIALS CHEMISTRY C (2020)
Significant improvement in superconducting properties of in situ powder-in-tube MgB2 wires through anthracene doping and heat treatment optimization
Chunyan Li et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2019)
Niobium-titanium (Nb-Ti) superconducting joints for persistent-mode operation
Dipak Patel et al.
SCIENTIFIC REPORTS (2019)
Extrinsic Two-Dimensional Flux Pinning Centers in MgB2 Superconductors Induced by Graphene-Coated Boron
Wenxian Li et al.
ACS APPLIED MATERIALS & INTERFACES (2019)
Superconducting Joints Made With Internal-Magnesium-Diffusion-Processed MgB2 Wires
Akiyoshi Matsumoto et al.
IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2018)
Investigation of multifilament MgB2 superconducting joint technique for development of MRI magnets
B. H. Yoo et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2018)
Ultra-lightweight superconducting wire based on Mg, B, Ti and AlUltra-lightweight superconducting wire based on Mg, B, Ti and Al
P. Kovac et al.
SCIENTIFIC REPORTS (2018)
Conductors for commercial MRI magnets beyond NbTi: requirements and challenges
Michael Parizh et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2017)
Towards liquid-helium-free, persistent-mode MgB2 MRI magnets: FBML experience
Yukikazu Iwasa
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2017)
Transport properties of multifilament MgB2 long wires and coils prepared by an internal Mg diffusion process
Dongliang Wang et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2017)
Solid cryogen: a cooling system for future MgB2 MRI magnet
Dipak Patel et al.
SCIENTIFIC REPORTS (2017)
Status of MgB2 wire and cable applications in Europe
A. Ballarino et al.
29TH INTERNATIONAL SYMPOSIUM ON SUPERCONDUCTIVITY (2017)
Evaluation of persistent-mode operation in a superconducting MgB2 coil in solid nitrogen
Dipak Patel et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2016)
The development of MgB2 superconducting wires fabricated with an internal Mg diffusion (IMD) process
Shujun Ye et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2016)
A new approach to a superconducting joining process for carbon-doped MgB2 conductor
Dipak Patel et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2016)
High performance MgB2 superconducting wires fabricated by improved internal Mg diffusion process at a low temperature
Yongchang Liu et al.
JOURNAL OF MATERIALS CHEMISTRY C (2016)
Kinetic analysis of MgB2 layer formation in advanced internal magnesium infiltration (AIMI) processed MgB2 wires
G. Z. Li et al.
ACTA MATERIALIA (2015)
Uniformity of Coronene-Added MgB2 Superconducting Wires Fabricated Using an Internal Mg Diffusion Process
ShuJun Ye et al.
IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2015)
Superior critical current density obtained in MgB2 bulks through low-cost carbon-encapsulated boron powder
Shaon Barua et al.
SCRIPTA MATERIALIA (2015)
MgB2 superconducting joints for persistent current operation
Dipak Patel et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2015)
Significantly enhanced critical current density in nano-MgB2 grains rapidly formed at low temperature with homogeneous carbon doping
Yongchang Liu et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2015)
Rational design of MgB2 conductors toward practical applications
Dipak Patel et al.
CRYOGENICS (2014)
Conduction cooled magnet design for 1.5T, 3.0T and 7.0T MRI systems
Tanvir Baig et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2014)
Novel technologies and configurations of superconducting magnets for MRI
Yuri Lvovsky et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2013)
Effects of carbon concentration and filament number on advanced internal Mg infiltration-processed MgB2 strands
G. Z. Li et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2013)
Towards the Realization of Higher Connectivity in MgB2 Conductors: In-situ or Sintered Ex-situ?
Akiyasu Yamamoto et al.
JAPANESE JOURNAL OF APPLIED PHYSICS (2012)
Development of superconducting magnet for high-field MR systems in China
Zanming Wang et al.
PHYSICA C-SUPERCONDUCTIVITY AND ITS APPLICATIONS (2012)
Microscopic role of carbon on MgB2 wire for critical current density comparable to NbTi
Jung Ho Kim et al.
NPG ASIA MATERIALS (2012)
Tailored Materials for High-Performance MgB2 Wire
Jung Ho Kim et al.
ADVANCED MATERIALS (2011)
The varied kinetics mechanisms in the synthesis of MgB2 from elemental powders by low-temperature sintering
Zongqing Ma et al.
MATERIALS CHEMISTRY AND PHYSICS (2011)
Prospects for improving the intrinsic and extrinsic properties of magnesium diboride superconducting strands
E. W. Collings et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2008)
Recent development of MgB2-based large scale applications
Roberto Penco et al.
IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2007)
Development of ex situ processed MgB2 wires and their applications to magnets
Valeria Braccini et al.
PHYSICA C-SUPERCONDUCTIVITY AND ITS APPLICATIONS (2007)
Overview of MgB2 superconductor applications
Michael Tomsic et al.
INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY (2007)
Alignment of carbon nanotube additives for improved performance of magnesium diboride superconductors
SX Dou et al.
ADVANCED MATERIALS (2006)
High performance new MgB2 superconducting hollow wires
G Giunchi et al.
SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2003)
High-Tc superconducting materials for electric power applications
D Larbalestier et al.
NATURE (2001)