Alternative Briquette Material Made from Palm Stem Biomass Mediated by Glycerol Crude of Biodiesel Byproducts as a Natural Adhesive

Recently, the global population has increased sharply, unfortunately, the availability of fossil fuel resources has significantly decreased. This phenomenon has become an attractive issue for many researchers in the world so that various studies in the context of finding renewable energy are developing continuously. Relating to this challenge, this research has been part of scientific work in the context of preparing an energy briquette employing palm oil stems and glycerol crude of biodiesel byproducts as inexpensive and green materials easily found in the Riau province, Indonesia. Technically, the palm oil stems are used for the production of charcoal particles and the glycerol crude as an adhesive compound in the production of energy briquettes. The heating value of palm oil stem is 17,180 kJ/kg, which can be increased to an even higher value through a carbonization process followed by a densification process so that it can be used as a potential matrix to produce energy briquettes. In detail, this study was designed to find out several parameters including the effect of sieve sizes consisting of 60, 80, and 100 mesh, respectively, which are used for the preparation of charcoal particles as the main matrix for the manufacture of the briquettes; the effect of charcoal-adhesive ratios (wt) of 60:40, 70:30, and 80:20; and the effect of varied pressures of 100, 110, and 120 kg/cm(2)on the briquette quality. The quality of the obtained briquettes is analyzed through the observation of important properties which involve the heating value and the compressive strength using Response Surface Methodology (RSM). The results showed that the produced briquettes had an optimum heating value of 30,670 kJ/kg, while their loaded charcoal particles resulted from the mesh sieve of 80, in which there was a charcoal loading of 53 g and it pressed at 93.1821 bar, whereas, the compressive strength value of the briquette was 100,608 kg/cm(2), which loaded charcoal particles from the mesh sieve of 100, the charcoal-adhesive ratio of 53:47 (wt) and the pressure of 93.1821 bar.