Simultaneous removal and oxidation of arsenic from water by δ-MnO2 modified activated carbon

The ubiquitous arsenic in groundwater poses a great risk to human health due to its environmental toxicity and carcinogenicity. In the present work, a new adsorbent, delta-MnO2 modified activated carbon, was prepared, and its performance for the uptake of arsenate and arsenite species from aqueous solutions was investigated by batch experiments. Various techniques, including FESEM-EDX, p-XRD, XPS and BET surface area analysis, were employed to characterize the properties of the adsorbent and the arsenic adsorption mechanisms. The results showed that delta-MnO2 covered on the surface and padded in the pores of the activated carbon. Adsorption kinetic studies revealed that approximately 90.1% and 76.8% of As(III) and As(V), respectively, were removed by the adsorbent in the first 9 hr, and adsorption achieved equilibrium within 48 hr. The maximum adsorption capacities of As(V) and As(III) at pH 4.0 calculated from Langmuir adsorption isotherms were 13.30 and 12.56 mg/g, respectively. The effect of pH on As(V) and As(III) removal was similar, and the removal efficiency significantly reduced with the increase of solution pH. Arsenite oxidation and adsorption kinetics showed that the As(V) concentration in solution due to As(III) oxidation and reductive dissolution of MnO2 increased rapidly during the first 12 min, and then gradually decreased. Based on the XPS analysis, nearly 93.3% of As(III) had been oxidized to As(V) on the adsorbent surface and around 38.9% of Mn(IV) had been reduced to Mn(II) after As(III) adsorption. This approach provides a possible method for the purification of arsenic-contaminated groundwater. (C) 2020 Published by Elsevier B.V. on behalf of The Research Centre for Eco-Environmental Sciences, Chinese Academy of Sciences.