Impact of Number of Operators and Distance to Branch Piles on Woodchipper Operation

Branch chipping machines with low-power engines are distinguished with an intermittent operation due to a periodical supply of branches. A conventional drive speed control of these machines is not adapted to adjust the operating mode depending on frequency of material supply for shredding. This article discusses the issues related to the assessment of the application of adaptive systems similar in design to start-stop systems used in vehicles, as necessary in the driving of this type machine. During testing, an impact of a distance between a branch pile from the woodchipper, a number of operators on frequency of drive unit operating condition changes, and the mass and volume output (productivity) were considered. A percentage ratio of the active and passive (idle) operation in selected conditions of use was also determined. A low-power 9.5 kW engine-powered cylindrical-type woodchipper was used for testing. Material chopped in the chipper was freshly cut branches of oaks (QuercusL. Sp. Pl. 994. 1753) with a diameter in the largest cross-section ca. 80 mm and moisture content ca. 25%. Piles of branches were located at three different distances from the chipper, i.e., 3 m, 9 m and 15 m. Branches to the chipper were fed by one or two operators. It was demonstrated that the idle run time in tested conditions with one operator could be from 43% to 71% of the entire operating time. Frequency of operating condition changes when only one operator worked and fluctuated from ca. 6 to 2 times per minute. Increasing the number of operators from one to two had a slight impact on the frequency of operating condition changes (by ca. 7%) at the shortest distance from the chipper (3 m). However, at larger distances, the additional operator may increase the frequency of operating condition changes of the chipper by 77% for 9 m distance and 85% for 15 m distance. The mass and volumetric output of the cylindrical chipper in the most advantageous case is equal to 0.66 t/h and 3.5 m(3)/h, respectively. The increase of the branch pile distance from the chipper causes a drop in mass output by 32%, and volumetric output by 33.5%. The results of the tests confirmed the necessity for the development of low-power chipping machines designed for clearing operations rather than industrial production of biomass. A direction for development could be systems that adapt driving units to operating conditions, depending on a demand for the chipping process.