4.6 Article

Effect of Adhesion on Mechanical and Tribological Properties of Glass Fiber Composites, Based on Ultra-High Molecular Weight Polyethylene Powders with Various Initial Particle Sizes

期刊

MATERIALS
卷 13, 期 7, 页码 -

出版社

MDPI
DOI: 10.3390/ma13071602

关键词

ultra-high molecular weight polyethylene; glass fiber; compatibilizer; adhesion; strength; wear resistance; permolecular structure; composition

资金

  1. ISPMS SB RAS [III.23.1.3]
  2. RFBR [20-58-00032 Bel_a, 19-38-90106]
  3. RF President Council [NSh-2718.2020.8]

向作者/读者索取更多资源

The aim of this study was to assess the effect of adhesion between the non-polar, ultra-high molecular weight polyethylene (UHMWPE) matrix and the glass fiber fillers of various lengths treated with the commercially available KH-550 agent, on the mechanical and tribological properties of the UHMWPE-based composites. The motivation was to find the optimal compositions of the polymer composite, for the compression sintering manufacturing of lining plates for the protection of marine venders and construction vehicles, as well as transport equipment. It was shown that the initial powder size at equal molecular weight determined the distribution patterns of the glass fibers in the matrix, and, as a consequence, the mechanical and tribological properties of the composites. Based on the obtained experimental data and the results of the calculation by a developed computer algorithm, control parameters were determined to give practical recommendations (polymer powder size and glass fiber length), for the production of the UHMWPE-composites having specified mechanical and tribological characteristics. The GUR4022 + 10% LGF composite, loaded with the chopped 3 mm glass fibers treated with the KH-550, was recommended for severe operating conditions (high loads, including impact and abrasive wear). For mild operating conditions (including cases when the silane coupling agent could not be used), the GUR2122 + 10% MGF and GUR2122 + 10% LGF composites, based on the fine UHMWPE powder, were recommended. However, the cost and technological efficiency of the filler (flowability, dispersibility) and polymer powder processing should be taken into account, in addition to the specified mechanical and tribological properties.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.6
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据