Evaluation of flake graphite ore using self-potential (SP), electrical resistivity tomography (ERT) and induced polarization (IP) methods in east coast of Madagascar

Multiple electrical geophysical survey techniques were used to evaluate the flaky graphite reserves found along the east coast of Madagascar. Self-potential (SP) combined with induced polarization (IP) and electrical resistivity tomography (ERT) methods were applied and provide information about the graphite ore spatial distribution. Unlike conventional geophysical survey methods that use SP and electromagnetic (EM) methods for exploration of this type of metal, the addition of IP and ERT offers a geoelectrical map and section which indicate correlations with the graphite content. The obtained SP map enabled us to delineate the mineralized area whereas the geoelectrical sections obtained from ERT and IP provide additional information on the vertical extent of the mineral of interest, in this case flake-graphite. We overlaid the graphite content, as measured on samples, on the SP map in order to verify the effectiveness of the geophysical methodology. Good correlation between negative SP anomalies and positive indication of graphite content confirms that the methods used in this study (SP, ERT and IP) are sensitive for delineation of the mineralized zone and consequent evaluation of the ore reserve. Resistivity and chargeability obtained from the inversion of the ERT/IP data are low and high, respectively, within the saturated zone inside SP-anomalous zones. The principal ore body is located in the lateritic zone composed of clay-rich formations derived from the weathering of gneiss and migmatite rocks. Negative SP anomalies, along with low electrical resistivity and high chargeability values, are found mainly in areas where the graphitic content exceeds 5%. (C) 2019 Elsevier B.V. All rights reserved.