相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Differentiation of γ′ and γ-precipitates in Inconel 718 by a complementary study with small-angle neutron scattering and analytical microscopy
R. Lawitzki et al.
ACTA MATERIALIA (2019)
On conventional versus direct ageing of Alloy 718
F. Theska et al.
ACTA MATERIALIA (2018)
Influence of stress on γ precipitation behavior in Inconel 718 during aging
Hailong Qin et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2018)
Assessment of the stress-oriented precipitation hardening designed by interior residual stress during ageing in IN718 superalloy
Hailong Qin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Experimental and numerical investigations of the γ and γ′ precipitation kinetics in Alloy 718
A. Drexler et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Effect of hydrogen charging on dislocation multiplication in pre-strained super duplex stainless steel
X. Z. Liang et al.
SCRIPTA MATERIALIA (2018)
Modelling the nucleation, growth and coarsening kinetics of γ (D022) precipitates in the Ni-base Alloy 625
I. J. Moore et al.
ACTA MATERIALIA (2016)
Predicting Coherency Loss of Precipitates in IN718 Superalloy
Yanzhou Ji et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2016)
Determination of the high temperature elastic properties and diffraction elastic constants of Ni-base superalloys
P. E. Aba-Perea et al.
MATERIALS & DESIGN (2016)
Imaging and characterization of γ′ and γ nanoparticles in Inconel 718 by EDX elemental mapping and FIB-SEM tomography
K. Kulawik et al.
MATERIALS CHARACTERIZATION (2015)
In-situ neutron diffraction measurement of stress redistribution in a dissimilar joint during heat treatment
M. F. Dodge et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Discontinuous Precipitation in Ni-Base Superalloys During Solution Heat Treatment
D. Welton et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2015)
Computer simulation of phase transformation and plastic deformation in IN718 superalloy: Microstructural evolution during precipitation
N. Zhou et al.
ACTA MATERIALIA (2014)
Microstructure and temperature dependence of intergranular strains on diffractometric macroscopic residual stress analysis
J. N. Wagner et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
GSAS-II: the genesis of a modern open-source all purpose crystallography software package
Brian H. Toby et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2013)
Lattice strain evolution during creep in single-crystal superalloys
James Coakley et al.
ACTA MATERIALIA (2012)
Deformation behaviour of an advanced nickel-based superalloy studied by neutron diffraction and electron microscopy
Benedict M. B. Grant et al.
ACTA MATERIALIA (2012)
Lattice strain evolution in a high volume fraction polycrystal nickel superalloy
James Coakley et al.
SCRIPTA MATERIALIA (2012)
Interphase microstress measurements in IN 718 by cold neutron diffraction
J. Repper et al.
APPLIED PHYSICS A-MATERIALS SCIENCE & PROCESSING (2010)
Elastic moduli and load partitioning in a single-crystal nickel superalloy
D. Dye et al.
SCRIPTA MATERIALIA (2009)
Gamma double prime precipitation kinetic in Alloy 718
A. Devaux et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
Evidence of variation in slip mode in a polycrystalline nickel-base superalloy with change in temperature from neutron diffraction strain measurements
M. R. Daymond et al.
ACTA MATERIALIA (2007)
ENGIN-X: a third-generation neutron strain scanner
J. R. Santisteban et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2006)
R factors in Rietveld analysis:: How good is good enough?
BH Toby
POWDER DIFFRACTION (2006)
Microstrain evolution during creep of a high volume fraction superalloy
S Ma et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
Microstress evolution during in situ loading of a superalloy containing high volume fraction of γ′ phase
S Ma et al.
SCRIPTA MATERIALIA (2003)
An optimum design for a time-of-flight neutron diffractometer for measuring engineering stresses
MW Johnson et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2002)
分享论文
