Prediction of soil hard -setting and physical quality using water retention data

Hard-setting soils become hard and compact during drying, and are therefore difficult or impossible to cultivate unless they are re-wetted. This study was done to quantify the hard-setting behavior on nine soils with a wide range of texture (from sandy loam to silty clay). Repacked soil cores were prepared with least disturbance of soil aggregates (05-4 mm). Water retention curves of the soils were measured in the matric suction range 10-15,000 hPa in different bulk densities (1.20-1.70 Mg m(-3)). Single-porosity van Genuchten-Mualem and dual-porosity Dexter models were fitted to the water retention data. Dexter's indices of soil physical quality (S) and hard-setting (H-Dexter) were calculated using the van Genuchten-Mualem parameters. Soil physical quality indices S-1 and S-2 (slopes of water retention curve at first and second inflection points, related to matrix and structural pore spaces, respectively) and new hard-setting indices (H-1 and H-2 related to matrix and structural pore spaces, respectively) were also calculated from the parameters of dual-porosity model. Tensile strength (Y) of the soil samples prepared at different bulk densities was also measured from near-saturation to oven-dry. Slopes of relationships between Y and water content were used as soil strength-based hard-setting indices. A larger slope means that the soil is more susceptible to hard-setting. The H-Dexter,H-1 and H-2 increased with an increment in the bulk density, whereas the S, S-1 and S-2 decreased. Significant positive relationships between hard-setting indices (H-Dexter and Hi) and calcium carbonate content were observed. Negative linear relations were derived between S, S-1 and S-2, and bulk density and positive linear relations were obtained between H-Dexier, H-1 and H-2, and bulk density. Soil hard-setting and physical quality indices were significantly correlated with relative bulk density. Positive relationships were observed between soil strength-based hard-setting indices and relative bulk density, and the correlations between these indices and H-2 and S-1 were significantly positive and negative, respectively. These findings confirmed that the new proposed indices enable prediction of soil hard setting behavior using only water retention data with no need to measure soil mechanical strength.