Use of Instream Structure Technique for Aquatic Habitat Formation in Ecological Stream Restoration

Drought flow as the minimum flow rate required for restoration of the Mokgamcheon stream was calculated by the Storm Water Management Model (SWMM) V.5.0. The adequacy of drought flow to guarantee the minimum ecological environment was assessed using suitable low-flows not exceeding the maximum pollution concentration of the ecosystem calculated by Design FLOWs (DFLOW) V.4.1. Fish flows, which provide proper ecological habitat for fish, were calculated using Physical HABitat SIMulation (PHABSIM) V.1.5.2 to provide proper ecological habitat for target fishes such as Carassius auratus and Zacco platypus. The monthly expected instream flows were determined as the largest value between drought flow and fish flow. In most cases, instream flows were determined by drought flows exceeding fish flows that satisfy the condition of species habitat, but in the case of Carassius auratus, drought flows were less than fish flows in April, September, and October. Thus, structural measures for the supply of additional discharge were required. Instead, when natural environment-friendly instream structures, such as stepping stones were used, affordable ecological restoration that met the preferred conditions for discharge and depth of Carassius auratus was possible. The stepping stones were assessed using River2D V.0.95a to measure their effectiveness compared to other structural measures that would be costly and time-consuming to secure shortage of fish flow. Finally, the stability of the habitat was assessed through flood analysis; in case of a flood discharge of 5.2 m(3)/s obtained from time-series analysis, it was evaluated that the stability of habitats could be reasonable.