Fabrication and Optimization of High Aspect Ratio Through-Silicon-Vias Electroplating for 3D Inductor

In this study, the filling process of high aspect ratio through-silicon-vias (TSVs) under dense conditions using the electroplating method was efficiently achieved and optimized. Pulsed power was used as the experimental power source and the electroplating solution was prepared with various additive concentrations. Designed control variable experiments were conducted to determine the optimized method. In the control variable experiments, the relationship of multiple experimental variables, including current density (0.25-2 A/dm(2)), additive concentration (0.5-2 mL/L), and different shapes of TSVs (circle, oral, and square), were systematically analyzed. Considering the electroplating speed and quality, the influence of different factors on experimental results and the optimized parameters were determined. The results showed that increasing current density improved the electroplating speed but decreased the quality. Additives worked well, whereas their concentrations were controlled within a suitable range. The TSV shape also influenced the electroplating result. When the current density was 1.5 A/dm(2) and the additive concentration was 1 mL/L, the TSV filling was relatively better. With the optimized parameters, 500-m-deep TSVs with a high aspect ratio of 10:1 were fully filled in 20 h, and the via density reached 70/mm(2). Finally, optimized parameters were adopted, and the electroplating of 1000-m-deep TSVs with a diameter of 100 m was completed in 45 h, which is the deepest and smallest through which a three-dimensional inductor has ever been successfully fabricated.