期刊
出版社
ELSEVIER SCIENCE SA
DOI: 10.1016/j.msea.2018.10.083
关键词
Selective laser melting; AlSi10Mg alloy; Melt pool boundary; Cellular structure; Anisotropy
类别
资金
- National Key Research and Development Program of China [2018YFB1105100]
- Key Research Program of Frontier Sciences, Chinese Academy of Sciences [QYZDB-SSW-JSC045]
- National Youth Thousand Plan Program
We describe here a comprehensive study on the effect of cellular structure and melt pool boundary (MPB) condition on the mechanical properties, deformation and failure behavior of AlSi10Mg alloy processed by selective laser melting (SLM). The morphology of melt pool (MP) on the load bearing face of tensile samples was significantly different with build directions. It resulted in different mechanical properties of the samples with different build directions. Furthermore, the microstructure analysis revealed that the MP in the SLM AlSi10Mg alloy mainly consisted of columnar alpha-Al grains which were made of ultra-fine elongated cellular structure. Electron back-scatter diffraction (EBSD) analysis revealed that the long axis of cellular structure and columnar grains were parallel to < 100 >, which resulted in < 100 > fiber texture in SLM AlSi10Mg alloy. However, Schmid factor calculation demonstrated that the anisotropy of mechanical properties of the SLM AlSi10Mg alloy built with different direction was mainly dependent on the distribution of MPB on the load bearing face, and not texture. The defects including pores, residual stress and heat affected zone (HAZ) located at MPB made it the weakest part in the SLM AlSi10Mg. The sample built along horizontal direction exhibited good combination of strength and plasticity and is attributed to the lowest fraction of MPBs that withstand load during tensile. MPB had strong influence on the mechanical properties and failure behavior of SLM AlSi10Mg built with different directions.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据