Removal of fluoride from groundwater using natural clay (kaolinite): Optimization of adsorption conditions

This article focuses on the application of clay, kaolinite, for the removal of fluoride ion from Saharan groundwater located in the Tindouf region (Algeria) because high concentrations are detected in potable water. Adsorption tests show that fluoride ion removal was efficient when the pH varies from 4.5 to 6. Under these conditions, the adsorption capacities were 0.442 and 0.448 mg/g, respectively. Kinetic and isotherm adsorption correlations were applied to describe the adsorption process. The results showed that the pseudo-second-order kinetic model and Freundlich isotherm fit well the experimental data. Thermodynamic calculation indicated that fluoride sorption into clay increased with increasing temperature from 30 to 55 degrees C, indicating the endothermic nature of sorption process. The investigation of the removal of fluoride from simulated potable water shows that the presence of nitrate and chloride ions did not influence the fluoride uptake. However, sulfate and carbonate ions decrease the adsorption capacity. Such results show that these ions may enter in competition with each other that may result in electrostatic repulsive forces between fluoride and clay surface. From this study, it can be concluded that the kaolinite is an effective and low-cost material for the removal of fluoride ions from groundwater. (C) 2018 Academie des sciences. Published by Elsevier Masson SAS. All rights reserved.