Effect of laser parameters on microstructure and hardness of laser clad and tempered AISI H13 tool steel

In the present study, laser cladding of AISI H13 tool steel powder has been undertaken on hardened and tempered AISI H13 tool steel components using a 6 kW fiber coupled diode laser both in continuous wave and pulsed mode with coaxial powder feeder to explore the possibility of reclamation/refurbishment of large AISI H13 tool steel components. Laser parameters in terms of laser power, processing speed and powder feed rate have been optimized to achieve acceptable clad-substrate integrity with optimum deposition height and width without any surface cracks and porosity. A detailed study of the effect of post-cladding heat treatment (both by laser assisted surface heating and conventional tempering at 550 degrees C) on the microstructure, phase aggregate, crystallite size, micro-strain and residual stress was carried out. Subsequently, the microhardness of the clad zone was evaluated. Pulsed laser cladding (heat input controlled) with 50 Hz frequency and 50% duty cycle with 10 ms ON-time developed a microstructure comprising martensite, retained austenite and mixed carbides. The maximum improvement in hardness (considered as a convenient index of strengthening) by laser cladding reached up to 650 VHN, which is about 45% higher than the hardness of hardened and tempered substrates. Post-cladding tempering at 550 degrees C for 2 h led to the development of uniform microstructure without fine carbide precipitated along grain boundaries or inter-dendritic regions taking the hardness to 600-650 VHN level. Laser reheating (tempering) of the clad zone with a 1000W laser power showed a more refined microstructure with maximum hardness up to 680-700 VHN. Residual stress, developed on the surface after laser cladding, was compressive in nature and measured higher in magnitude after pulsed laser cladding. Magnitude of this residual compressive stress marginally decreased after post-cladding tempering either by conventional or laser assisted route. Thus, the novelty of the present study lies in the continuous or pulsed mode laser cladding assisted reclamation of AISI H13 hot working dies with similar composition powder, followed up with conventional or laser assisted tempering, leading to the development of about 45% higher hardness (than as hardened and tempered conditions) and retention of residual compressive stress on the surface after cladding. (C) 2014 Elsevier B.V. All rights reserved.