Equilibrium and Kinetic Studies of Ni (II) Adsorption using Pineapple and Bamboo Stem Based Adsorbents

This work addresses the preparation and characterization of inexpensive adsorbents for the removal of Ni (II) from aqueous solutions. Activated carbon based adsorbents have been prepared from plant based biomass resources, namely Pineapple stem ( Ananas Comosus ) and Bamboo Stem ( Bambuseae ). Adopting phosphoric acid and heat treatment techniques, it has been observed that the bamboo stem activated charcoal (BSAC) and pineapple stem (PS) adsorbents had a BET surface area of 116 and 11.47m( 2 )/g, respectively. FTIR analysis indicated that various surface functional groups (such as C equivalent to N stretching, stretching vibration of C=O, -CH3 wagging and C-O stretching vibration) contribute towards Ni (II) adsorption. Batch mode adsorption experiments were conducted for these adsorbents in the range of 50-300mg/L Ni (II) solution concentration, 2-10pH, 15-300min. contact time, and 0.02-0.1g/50mL dosage. The BSAC adsorbent has been characterized with a metal uptake and %removal of 121.72mg/g and 92.47, respectively, which corresponds to 45% higher metal uptake than corresponding bamboo based adsorbents presented in the literature. Further experimentation with BSAC enabled to achieve activated charcoal with surface area values similar to that of the commercial activated carbon adsorbent. The bamboo adsorbent has also been evaluated to perform similar to the commercial activated carbon for the removal and recovery of Pd (II) from synthetic electroless plating solutions. Also, a conceptual cost analysis indicated and affirmed towards the potential of the BSAC adsorbents for waste water treatment applications.