相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Spray evolution, engine performance, emissions and combustion characterization of Karanja biodiesel fuelled common rail turbocharged direct injection transportation engine
Avinash Kumar Agarwal et al.
INTERNATIONAL JOURNAL OF ENGINE RESEARCH (2016)
A robust method for high-precision quantification of the complex three-dimensional vasculatures acquired by X-ray microtomography
Hai Tan et al.
JOURNAL OF SYNCHROTRON RADIATION (2016)
EXPERIMENTAL STUDY ON INJECTION AND MACROSCOPIC SPRAY CHARACTERISTICS OF ETHYL OLEATE, JET FUEL AND THEIR BLEND ON A DIESEL ENGINE COMMON RAIL SYSTEM
Yaozong Duan et al.
ATOMIZATION AND SPRAYS (2015)
Effect of the number and position of nozzle holes on in- and near-nozzle dynamic characteristics of diesel injection
Seoksu Moon et al.
FUEL (2015)
Experimental study on the two stage injection of diesel and gasoline blends on a common rail injection system
Dong Han et al.
FUEL (2015)
Development and application of an automatic measurement method for nozzle orifice diameter and length
Zhi-long Li et al.
JOURNAL OF ZHEJIANG UNIVERSITY-SCIENCE A (2015)
New method for measuring diesel nozzle orifice inlet structures based on synchrotron X-ray tomography
Zhilong Li et al.
CHINESE OPTICS LETTERS (2014)
Flash Boiling: Easy and Better Way to Generate Ideal Sprays than the High Injection Pressure
Min Xu et al.
SAE INTERNATIONAL JOURNAL OF FUELS AND LUBRICANTS (2013)
Comparisons of nozzle orifice processing methods using synchrotron X-ray micro-tomography
Zhi-jun Wu et al.
JOURNAL OF ZHEJIANG UNIVERSITY-SCIENCE A (2012)
Effect of nozzle orifice geometry on spray, combustion, and emission characteristics under diesel engine conditions
Sibendu Som et al.
FUEL (2011)
Numerical simulation of wall roughness effects in cavitating flow
F. Echouchene et al.
INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW (2011)
Form measurement inside fuel injector nozzle spray holes
Erwin Peiner et al.
MICROELECTRONIC ENGINEERING (2009)
Diesel nozzle geometry influence on spray liquid-phase fuel penetration in evaporative conditions
R. Payri et al.
FUEL (2008)
Sequential laser and EDM micro-drilling for next generation fuel injection nozzle manufacture
Lin Li et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2006)
Analysis of the influence of diesel nozzle geometry in the injection rate characteristic
J Benajes et al.
JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME (2004)
Innovative measurement techniques series:: Part 3 -: New technique for determination of internal geometry of a diesel nozzle with the use of silicone methodology
V Macian et al.
EXPERIMENTAL TECHNIQUES (2003)
分享论文
