Quartz crystal microbalance and spectroscopy measurements for acid doping in polyaniline films

We investigated the doping of thin polyaniline (PANI) films, prepared by the chemical oxidation of aniline, with different acids. The initial step in the investigation is the preparation of PANI films from aqueous hydrochloric acid solution. This is followed by dedoping with ammonia to obtain a PANI base, which is subsequently doped with strong acids ( e. g. hydrochloric, sulfuric, phosphoric and trichloroacetic acids) and with a weak acid ( acetic acid). The dopant weight fraction (w), which is connected with the gain of mass during the doping of PANI, was determined in situ using a quartz crystal microbalance (QCM). The behavior of PANI upon doping with different anions derived from strong acids indicates that both proton and the anion uptake into the polymer chains occur sharply, rapidly, completely, and reversibly. However the uptake in the case in acetic acid is characterized by slow diffusion. The doping was studied at different concentrations of acetic acid. A second cycle of dedoping - redoping was also performed. The kinetics of the doping reaction is dominated by Fickian diffusion kinetics. The diffusion coefficients (D) of the dopant ions into the PANI chains were determined using the QCM and by UV-Vis absorption spectroscopy in the range of (0.076-1.64) x 10(-15) cm(2) s(-1). It was found that D in the second cycle of doping is larger than that evaluated from the first cycle of doping for high concentrations of acetic acid. D for the diffusion and for the dopant ion expulsion from the PANI chains was also determined during the redoping process. It was found that D for acetic acid ions in the doping process is larger than that calculated for the dedoping process.