Direct determination of bromine in plastics by electrothermal vaporization/inductively coupled plasma mass spectrometry using a tungsten boat furnace vaporizer and an exchangeable sample cuvette system

A tungsten boat furnace vaporization inductively coupled plasma mass spectrometry (TBF/ICP-MS) method has been applied to the direct determination of bromine in plastic samples. In the pretreatment, the plastic sample is spread over a small sample cuvette made of tungsten by treating it with a strongly basic organic solution, e.g., octanol or diisobutyl ketone in the presence of potassium hydroxide. The cuvette is placed on a tungsten boat furnace, with which the electrothermal vaporizer is equipped. At the vaporization step, a widely spread thin layer of the sample facilitates its efficient evaporation and introduction into an ICP mass spectrometer. The most remarkable feature is that all the bromine species in plastic samples are decomposed to form a thermally stable inorganic salt during the pretreatment procedure. Therefore, the bromine content in plastic samples can be measured by a calibration curve method constructed with an aqueous standard solution of potassium bromate(V). The detection limit (3 sigma) was estimated to be 0.77 pg of bromine, which corresponds to a concentration of 0.31 ng g(-1) of bromine in plastic samples when a sample amount taken of 2.5 mg is studied. The relative standard deviation was calculated to be 2.2%. Analytical results of some plastic samples, which contained both inorganic bromide salts and also organic bromine species, are given. Copyright (C) 2010 John Wiley & Sons, Ltd.