期刊
出版社
SAGE PUBLICATIONS LTD
DOI: 10.1177/0954406212469167
关键词
Machining; milling; cutting forces; Inconel 718; modeling; constitutive law
This article presents a cutting force model for the milling of Inconel 718 whose machinability is considered to be very poor. The Johnson-Cook constitutive material model is used to determine the flow stress of Inconel 718 while the shear angle is determined based on a shear plane model assuming that the total energy on the shear plane plus the energy on the rake face is minimum. The temperature in the machining region is determined by using an iterative process. Finally, the cutting forces on each tooth of the milling cutter are calculated from its chip load considering the oblique cutting effects. The model is then verified by comparing the model predictions with the experimental data under the corresponding conditions, which shows a relatively good agreement with an average percentage error of 10.5% along the feed and normal directions.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据