Experimental investigation on reprocessing of extruded wood flour/HDPE composites

This article presents an experimental study on the change in the properties of woodplastic composites (WPCs) when reprocessed. The degree of properties degradation upon reprocessing, for recycling purpose, can be considered as a key factor to choose an alternative against discarding into the environment. A material which retains its properties when recycled, or at least exhibits insignificant reduction in its properties, is favorable in environmental point of view. To investigate the reprocessing effect on the WPC properties, in this study, cylindrical profiles of WPC, with 60 wt% of wood content, were produced using a twin screw extruder, at first stage (virgin WPC). These profiles were then chopped into granules and used in the reproduction of the same shaped product (recycled WPC). For the measurement of mechanical properties, tensile and three-point bending tests were conducted. Differential scanning calorimetry (DSC) test was performed to compare thermal behavior of the neat HDPE, virgin and recycled composites. Scanning electron microscopy (SEM) images were also produced to observe the adhesion quality of the components and changes in wood particles size. Physical properties such as density and water uptake were also measured. A reduction in strength was observed upon recycling which was accompanied with the decrease in density, while an increase in the flexural modulus was noticed. The results also indicate that the recycled samples exhibit a higher water uptake. Analysis of thermal behavior showed a slight increase in the melting temperature of the reprocessed composite and decrease in the degree of crystallinity especially at the first stage of the HDPE process. POLYM. COMPOS., 2012. (c) 2012 Society of Plastics Engineers