期刊
出版社
SPRINGER
DOI: 10.1007/s00542-008-0714-0
关键词
-
类别
资金
- State of Louisiana
- CAMD
The optic alignment module containing out-of-plane 3D micro lenses, and micro optic fiber holders have been fabricated using tilted UV lithography technique in water with SU-8 photoresist (Ling and Lian in Proc SPIE 4979:402-409, 2007). Each holder is a circumscribed quadrilateral formed by a V-groove and pairs of fixed microclips, which will hold the fiber in position through the elastic deformation when the fiber is inserted. Since these microclips were fixed cantilever beams and its effective beam length, the distance between the fixed end of the beam and beam-fiber contact point, is very short (62.5 mu m), the stress on the beam is high even under a small (few microns) deformation. The inserted optical fiber was either too loose to lose its alignment accuracy, or too tight causing the clips to break because of dimensional tolerance. It becomes very difficult, if not impossible, to use them in practical applications. Therefore, the key issue of fabricating optical alignment module is to have a suitable stiffness of microclips with an appropriate deformation during the fiber insertion, which can provide enough force to hold the fiber for accurate alignment and avoid introducing neither significant viscous deformation nor the damage to the clips. In this paper, a novel technique to fabricate SU-8 cantilever beam as elastic clamping device in optical fiber holder is proposed. Simulation based on SU-8 material properties indicates that for a 250-mu m-long, 50-mu m-thick SU-8 beam the clamping force per unit beam width will range from 10 to 100 Newton/m as the deflection increased from 1.4 to 14 mu m. This predicted performance is comparable to or even better than that of existing silicon nitride microclips in optical fiber holding application [Bostock et al. in J Micromech Microeng 8(4):343-360, 1998]. By using a two-mask process, we have fabricated free-end cantilever beams as fiber holding clips. In order to have longer beams over V-groove, the slots in the V-groove were introduced, which allow the beams extended deeper into the sloped V-groove walls. The micro alignment module with 250-mu m-length cantilever beams as microclips for housing 125-mu m-diameter optical fibers has been successfully fabricated using a 300-mu m-thick SU-8 photoresist layer by a two-mask UV lithography processes. This approuch offers significant advantages over other techniques with respect to costs of material, simple in equipment, and easy in manufacture. These optical fiber holders with elastic microclips combined with pre-aligned out-of-plane 3D micro lenses make it possible that to build an integrated micro optic system with precise alignment accuracy on a wafer-scale.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据