Early Stages of Recrystallization in Equal-Channel Angular Pressing (ECAP)-Deformed AA3104 Alloy Investigated Using Scanning Electron Microscopy (SEM) and Transmission Electron Microscopy (TEM) Orientation Mappings

Early stages of recrystallization in alloys containing complex structure of second phase particles are of considerable practical interest. They were observed for the AA3104 alloy in which large particles occur against the background of randomly distributed dispersoids. The samples were deformed by equal channel angular pressing and then slightly annealed to obtain the state of partial recrystallization. The highly deformed alloy contained a structure of flat grains with the spacing between high-angle grain boundaries ranging from 100 nm to 1 A mu m. On annealing, the structure coarsened and got transformed into nearly equiaxed grains by both discontinuous and continuous recrystallization. The nucleation of new grains was observed in statically recrystallized bulk samples using scanning electron microscopy, and during in-situ recrystallization in a transmission electron microscope. Special attention was paid to the nucleation of new grains in areas close to large second phase particles, where a relatively high stored energy was expected to stimulate nucleation. A particular role in the rise of nuclei is attributed to migration of low angle boundaries. During recrystallization at 623 K (350 A degrees C), in most of the observed cases, the growth of grains occurred by coalescence of neighbouring cells and by migration of high-angle grain boundaries. These processes led to nearly equiaxed grains of similar size. Orientation mappings showed that although orientations of new grains were widely scattered, they were not completely random.