Friction-stir welding of an Al-Mg-Sc-Zr alloy in as-fabricated and work-hardened conditions

The effect of prior work hardening on the microstructure and mechanical properties of a friction-stir welded (FSWed) Al-5.4Mg-0.2Sc-0.1Zr alloy was investigated. The microstructure of the final stir zone was shown to be weakly dependent on the initial condition of the base material; FSW led to the formation of fully recrystallized microstructures with average grain sizes ranging from 1.2 to 1.5 mu m and a moderate dislocation density of similar to 3.5 +/- 1.5 x 10(13) m(-2) in the stir zone. The nano-scale Al-3(Sc,Zr) dispersoids coarsened from 9 to similar to 15 nm but retained a coherent relationship with the matrix. In contrast, the joint efficiency of the obtained welds was very sensitive to the initial material condition. Nearly full strength joints were obtained in both annealed (O) and partially hardened and stabilized (H323) conditions. However, the joint efficiency was only 65% in the fully hardened condition (H18). The relatively low weld strength for the alloy in the H18 condition was attributed to the elimination of dislocation and substructure strengthening during FSW. (c) 2014 Elsevier B.V. All rights reserved.