期刊
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
卷 510-11, 期 -, 页码 289-294出版社
ELSEVIER SCIENCE SA
DOI: 10.1016/j.msea.2008.04.097
关键词
Inconel 718 superalloy; Heat treatment; delta phase; Microstructure; Creep; Grain boundary sliding
Standard heat treatment (HT1) for Inconel 718 superalloy is solutionizing at 1095 degrees C, 1 h/AC, then aging at 955 degrees C, 1 h/AC + 720 degrees C, 8 h/FC 57 K/h to 620 degrees C, 8 h/AC. In order to study the aging effects of the delta phase, two more conditions HT2 (no aging condition 955 degrees C) and HT3 (955 degrees C. 3.5 h/AC) were studied in this research. Lever arm creep tests were performed at 650 degrees C under constant stress 625 MPa. Since HT2 produces no delta phase, the stress rupture life, creep elongation to failure and steady state creep rate of HT2 are largest among these three aging conditions. However, increasing the 955 degrees C aging time, the stress rupture life, creep elongation and steady state creep rate raise slightly as compared to HT1, because platelet delta phase is more uniformly nucleated and more direction oriented at grain boundaries. Fractographs show ductile fracture patterns mostly and, small portion of inter-granular fracture in the HT2 specimens. Generally only inter-granular fracture is observed in the other two cases of HT1 and HT3. Besides twinning and dislocation mechanisms, grain boundary sliding is also activated, so that creep elongation to failure of HT2 specimens could reach 5.6%, whereas 1% for the other two schemes. (C) 2008 Elsevier B.V. All rights reserved.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据