相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。Gas turbine coatings - An overview
R. Rajendran
ENGINEERING FAILURE ANALYSIS (2012)
Novel (Ir,Sn,Nb)O2 anode electrocatalysts with reduced noble metal content for PEM based water electrolysis
Karan Kadakia et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2012)
Effect of nanostructuring and Al alloying on corrosion behaviour of thermal sprayed WC-Co coatings
A. K. Basak et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)
A review on surface control of thermal radiation by paints and coatings for new energy applications
S. Wijewardane et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2012)
Influence of Pre-Heated Al 6061 Substrate Temperature on the Residual Stresses of Multipass Al Coatings Deposited by Cold Spray
Silvano Rech et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2011)
Formation of Cold-Sprayed Ceramic Titanium Dioxide Layers on Metal Surfaces
J. -O. Kliemann et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2011)
Performance of a Ni/Al2O3 cermet-supported tubular solid oxide fuel cell operating with biomass-based syngas through supercritical water
Cheng-Xin Li et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2010)
A study on powder mixing for high fracture toughness and wear resistance of WC-Co-Cr coatings sprayed by HVOF
C. W. Lee et al.
SURFACE & COATINGS TECHNOLOGY (2010)
Fatigue resistance and failure mechanisms of plasma-sprayed CrC-NiCr cermet coatings in rolling contact
X. C. Zhang et al.
INTERNATIONAL JOURNAL OF FATIGUE (2009)
From Particle Acceleration to Impact and Bonding in Cold Spraying
Tobias Schmidt et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2009)
Influence of Ceramic Powder Size on Process of Cermet Coating Formation by Cold Spray
A. Sova et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2009)
Effect of Ceramic Particles on Properties of Cold-Sprayed Ni-20Cr+Al2O3 Coatings
Heli Koivuluoto et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2009)
Fabrication and optimisation of highly efficient cermet-based spectrally selective coatings for high operating temperature
S. Esposito et al.
THIN SOLID FILMS (2009)
Characterizations of cold-sprayed Nickel-Alumina composite coating with relatively large Nickel-coated Alumina powder
Wen-Ya Li et al.
SURFACE & COATINGS TECHNOLOGY (2008)
Microstructure and spectral selectivity of Mo-Al2O3 solar selective absorbing coatings after annealing
Du Xinkang et al.
THIN SOLID FILMS (2008)
Investigation of Al-Al2O3 cold spray coating formation and properties
Eric Irissou et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2007)
Wear behaviour of thermally sprayed ceramic oxide coatings
Giovanni Bolelli et al.
WEAR (2006)
Challenges and advances in nanocomposite processing techniques
V. Viswanathan et al.
MATERIALS SCIENCE & ENGINEERING R-REPORTS (2006)
Determination of mechanical properties of aluminium matrix composites constituents
J. Rodriguez et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)
Metal particle deposition stimulation by surface abrasive treatment in gas dynamic spraying
A. Shkodkin et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2006)
A systematic approach to material eligibility for the cold-spray process
J Vlcek et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2005)
Bonding mechanism in cold gas spraying
H Assadi et al.
ACTA MATERIALIA (2003)
Deposition of PVD solar absorber coatings for high-efficiency thermal collectors
C Nunes et al.
VACUUM (2002)
Spectrally selective composite coatings of Cr-Cr2O3 and Mo-Al2O3 for solar energy applications
V Teixeira et al.
THIN SOLID FILMS (2001)