Temperature-dependent mechanical and long crack behavior of zirconium diboride-silicon carbide composite

Hot pressed ZrB2-20 vol.% SiC ultra-high temperature ceramic composites have been prepared for strength and fracture investigations. Two composites fabricated under differing hot pressing temperatures with (ZSB) and without (ZS) B4C sintering aids were selected for room temperature modulus of rupture (MOR) strength and single-edge-notch bend (SENB) fracture toughness experiments. Structure property relationships were examined for both composites. MOR and stiffness temperature dependence was also investigated up to 1500 degrees C. Long crack propagation studies were conducted up to 1400 degrees C using the double cantilevered beam geometry with half-chevron-notch initiation zones. Residual Boron-rich carbide maximum particle sizes were found to be strength limiting in ZSB billets while SiC controlled strength in ZS billets. Flexure strength decreased linearly with temperature from 1000 to 1500 degrees C with no visible plastic deformation prior to fracture. Similar stiffness decreases were observed with a transition temperature range of 1100-1200 degrees C. Long crack studies produced R-curves that show no significant toughening behavior at room temperature with some modest rising R-curve behavior appearing at higher temperatures. These studies also show the plateau toughness increases with temperature up to 1200 degrees C. This is supported by an observed transition from primarily transgranular fracture at room temperature to primarily intergranular fracture at high temperatures. Wake zone toughening is evident up to 1000 degrees C with K-R rise from 0.1 to 0.5 MPa root m. Beyond 1000 degrees C fracture mechanism transitions to include creep zone development ahead of crack tip with wake zone toughening vanishing. (c) 2012 Elsevier Ltd. All rights reserved.