期刊
JOURNAL OF POWER SOURCES
卷 180, 期 1, 页码 132-142出版社
ELSEVIER SCIENCE BV
DOI: 10.1016/j.jpowsour.2008.01.075
关键词
thermal plasma spraying; nanostructured anode; solid oxide fuel cells
Intermediate temperature solid oxide fuel cells (ITSOFCs) supported by a porous Ni-substrate and based on Sr and Mg doped lanthanum gallate (LSGM) electrolyte, lanthanum strontium cobalt ferrite (LSCF) cathode and nanostructured yttria stabilized zirconia-nickel (YSZ/Ni) cermet anode have been fabricated successfully by atmospheric plasma spraying (APS). From ac impedance analysis, the sprayed YSZ/Ni cermet anode with a novel nanostructure and advantageous triple phase boundaries after hydrogen reduction has a low resistance. It shows a good electrocatalytic activity for hydrogen oxidation reactions. The sprayed LSGM electrolyte with similar to 60 mu m in thickness and similar to 0.054 S cm(-1) conductivity at 800 degrees C shows a good gas tightness and gives an open circuit voltage (OCV) larger than 1 V. The sprayed LSCF cathode with similar to 30 mu m in thickness and similar to 30% porosity has a minimum resistance after being heated at 1000 degrees C for 2 h. This cathode keeps right phase structure and good porous network microstructure for conducting electrons and negative oxygen ions. The APS sprayed cell after being heated at 1000 degrees C for 2 h has a minimum inherent resistance and achieves output power densities of similar to 440 mW cm(-2) at 800 degrees C, similar to 275 mW cm(-2) at 750 degrees C and similar to 170 mW cm(-2) at 700 degrees C. Results from SEM, XRD, ac impedance analysis and I-V-P measurements are presented here. (C) 2008 Elsevier B.V. All rights reserved.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据