期刊
JOURNAL OF PHARMACEUTICAL AND BIOMEDICAL ANALYSIS
卷 51, 期 1, 页码 230-235出版社
PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.jpba.2009.08.019
关键词
Ciclopirox; Penlac; Direct analysis; LC/MS/MS; In vitro nail penetration
Due to severe chelating effect caused by N-hydroxylpyridone group of ciclopirox, there is no published direct HPLC or LC/MS/MS method for the determination of ciclopirox in any in vitro or in vivo matrix. Instead, the time-consuming pre-column derivatization methods have been adapted for indirect analysis of ciclopirox. After overcoming the chelating problem by using K(2)EDTA coated tubes, a direct, sensitive and high-throughput LC/MS/MS method was successfully developed and validated to determine the amount of ciclopirox that penetrated across the nail plate during in vitro nail penetration studies. The method involved adding a chemical analog, chloridazon as internal standard (IS) in K2EDTA coated tubes, mixing IS with ciclopirox in a 96-well plate and then proceeding to LC/MS/MS analysis. The MS/MS was selected to monitor m/z 208.0 -> 135.8 and 221.8 -> 77.0 for ciclopirox and 15, respectively, using positive electrospray ionization. The method was validated over a concentration range of 8-256 ng/mL, yielding calibration curves with correlation coefficients greater than 0.9991 with a lower limit of quantitation (LLOQ) of 8 ng/mL. The assay precision and accuracy were evaluated using quality control (QC) samples at three concentration levels. Analyzed concentrations ranged from 101% to 113% of their respective nominal concentration levels with coefficients of variation (CV) below 10.6%. The average recovery of ciclopirox from nail matrix was 101%. The validated method was successfully used to analyze the ciclopirox formulation and in vitro nail penetration samples. (C) 2009 Elsevier B.V. All rights reserved.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据