相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Evaluation of Parameters for Assessment of Inter-Splat Bond Strength in Cold-Sprayed Coatings
G. Sundararajan et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2010)
Advanced deposition characteristics of kinetic sprayed bronze/diamond composite by tailoring feedstock properties
Hyuntaek Na et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2009)
The influence of heat treatment on the microstructural, mechanical and corrosion behaviour of cold sprayed SS 316L coatings
G. Sundararajan et al.
JOURNAL OF MATERIALS SCIENCE (2009)
General aspects of interface bonding in kinetic sprayed coatings
Gyulyeol Bae et al.
ACTA MATERIALIA (2008)
Low temperature deposition and characterization of TiO2 photocatalytic film through cold spray
Guan-Jun Yang et al.
APPLIED SURFACE SCIENCE (2008)
High strain rate deformation microstructures of stainless steel 316L by cold spraying and explosive powder compaction
C. Borchers et al.
APPLIED PHYSICS A-MATERIALS SCIENCE & PROCESSING (2008)
The effects of powder properties on in-flight particle velocity and deposition process during low pressure cold spray process
Xian-Jin Ning et al.
APPLIED SURFACE SCIENCE (2007)
Deposition characteristics of Al-12Si alloy coating fabricated by cold spraying with relatively large powder particles
W.-Y. Li et al.
APPLIED SURFACE SCIENCE (2007)
Optimal design of a cold spray nozzle by numerical analysis of particle velocity and experimental validation with 316L stainless steel powder
Wen-Ya Li et al.
MATERIALS & DESIGN (2007)
In-flight particle velocity measurements with DPV-2000 in cold spray
Hirotaka Fukanuma et al.
SURFACE & COATINGS TECHNOLOGY (2006)
Corrosion behavior of wire-arc-sprayed stainless steel coating on mild steel
Z. Zeng et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2006)
The cold spray process and its potential for industrial applications
Frank Gaertner et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2006)
Development of a generalized parameter window for cold spray deposition
T Schmidt et al.
ACTA MATERIALIA (2006)
Characterization of the spraying beads deposited by the kinetic spraying process
H Choi et al.
SURFACE & COATINGS TECHNOLOGY (2005)
A systematic approach to material eligibility for the cold-spray process
J Vlcek et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2005)
Interfacial studies between cold-sprayedWO3, Y2O3 films and Si substrate
HY Lee et al.
APPLIED SURFACE SCIENCE (2004)
Surface oxide fracture in cold aluminium rolling
HR Le et al.
ACTA MATERIALIA (2004)
Corrosion stability of SUS316L HVOF sprayed coatings as lightweight bipolar plate materials in PEM fuel cells
KM El-Khatib et al.
ANTI-CORROSION METHODS AND MATERIALS (2004)
Microstructural and macroscopic properties of cold sprayed copper coatings
C Borchers et al.
JOURNAL OF APPLIED PHYSICS (2003)
分享论文
