Experiment and simulation of the compositional evolution of Ti-B thin films deposited by sputtering of a compound target

The evolution of the coating stoichiometry with pressure, target-substrate distance, and angle was analyzed for dc sputtering of TixB (x=0.5, 1, 1.6) compound targets by elastic recoil detection analysis. For an investigation of the underlying fundamental processes primarily Ar was used as sputter gas. Additionally, the effect of a reactive gas (N-2) as well as bias voltage (floating up to -200 V) was briefly cross-checked. For deposition along the target normal (90 degrees) a pronounced Ti-deficiency of up to 20% is detected. Increasing the pressure or distance from 0.5 to 2 Pa and from 5 to 20 cm, respectively, leads to an almost equivalent linear increase in TUB ratio surpassing even the target composition. Off-axis depositions at lower angles (30 degrees and 60 degrees) on the other hand result in a higher Ti/B ratio. This is consistent with results obtained from Monte Carlo simulations combining the respective emission characteristics from the sputter process as well as the gas-phase transport. Hence, the pressure, distance, and sample position induced changes in chemical film composition can be understood by considering gas scattering and the angular distribution of the sputtered flux. The theoretically determined transition from a directional flux to thermal diffusion was experimentally