Unintended potential impact of perfect sink conditions on PLGA degradation in microparticles

Yet, no standardized test method for drug release measurements from PLGA-based microparticles has been generally agreed on, or described by the regulatory authorities. Often, perfect sink conditions are provided in vitro to avoid artificial drug saturation effects. However, the maintenance of such conditions might strongly affect PLGA degradation. The involved physicochemical processes are complex and the potential impact of perfect sink conditions is not yet well understood. Differently sized, highly porous, carbamazepine- and ibuprofen-loaded PLGA microparticles were prepared by a W/O/W emulsion solvent extraction/evaporation technique. The initial drug loading was intentionally low (3-4%) so that the two drugs were molecularly dispersed within the polymeric matrices (monolithic solutions). This was important to be able to exclude potential limited drug solubility effects on the resulting release kinetics. Drug release into phosphate buffer pH 7.4 was measured under perfect sink conditions. SEC, DSC and SEM were used to characterize polymer degradation. The decrease in the average polymer molecular weight, glass transition temperature as well as changes in the inner and outer morphology of the PLGA microparticles were strongly affected by the bulk fluid's volume. In the case of the poorly water-soluble drug carbamazepine, much lower microparticle mass:phosphate buffer volume ratios were required to maintain perfect sink conditions, resulting in stable pH values within the bulk fluid, slower PLGA degradation and, thus, lower drug release rates. Thus, great care has to be taken when defining the conditions for in vitro drug release measurements from PLGA-based microparticles, avoiding potentially artificial conditions for polymer degradation. (C) 2010 Elsevier B.V. All rights reserved.