Measurement accuracy of a mono-fiber optical probe in a bubbly flow

The measurement accuracy of a mono-fiber optical probe is studied experimentally using isolated bubbles rising freely in a still liquid. The dwell time of the probe tip within the gas phase, which is obtained from both the optical probe signal and high-speed visualization, is compared with the value expected for a non-perturbed bubble. The difference originates mainly from the intrusive nature of the optical probe, which modifies the bubble behavior when it comes into contact with the probe tip. This interaction increases the dwell time if the bubble is pierced by the probe near its pole, and shortens it for piercing near the equator. The mean dwell time, obtained by averaging for various piercing locations, is shortened and the local void fraction indicated by the probe is thus underestimated. It is shown that the void fraction error can be correlated with a modified Weber number, and this correlation is helpful for sensor selection and for uncertainty estimate. In addition, the distribution of gas dwell time usually differs from the response expected for an ideal probe. This deviation results from the dependence of the dwell time error on the piercing location. The dwell time distribution can be used to infer the dependence of the dwell time on the piercing location. Finally, the deformation of long fibers during the bubble-probe interaction significantly increases the measurement error. Observed results are consistent with data of Andreotti (2009), which were measured in an airlift flow, suggesting that present results are applicable also to the case of moving liquid. Conclusions of this study could be applied also to conductivity probes or more generally to the interaction of a bubble with any kind of thin, intrusive sensor or fiber. (C) 2010 Elsevier Ltd. All rights reserved.