期刊
INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES
卷 28, 期 8, 页码 436-444出版社
ELSEVIER SCI LTD
DOI: 10.1016/j.ijadhadh.2008.04.009
关键词
composites; mechanical properties of adhesives; lap joints
The paper deals with experimental investigations on reinforcing the adhesive in single lap joints subjected to mechanical loads such as tensile, bending, impact and fatigue. The adhesive used for bonding was an epoxy reinforced with unidirectional and chopped glass fibres as well as micro-glass powder. The adherends were glass reinforced composite laminates. The bonding surfaces were prepared before joining. In the case of unidirectional fibres in the adhesive region, the fibre orientations considered were 0 degrees, 45 degrees and 90 degrees, The volume fraction of fibres in the adhesive layer in all the cases was 30%. The volume fractions of micro-glass powder were 20%, 30% and 40%. The tensile, bending, impact and fatigue tests on the prepared specimens were conducted according to ASTM standards. The results show that except the 90 degrees unidirectional orientation, reinforcing the adhesive with glass fibres or powder increases the joint strength. The use of volume fraction of 30% of micro-glass powder gave the best performance in the above loading conditions. The fatigue life increased by 125%, the ultimate joint strength in tension increased by 72%, the bending ultimate joint strength increased by 112% and the impact joint strength increased by 63%. The microstructure of the debonded area was examined and three modes of failure could be observed namely cohesive failure, light fibre-tear failure and thin layer cohesive failure. (c) 2008 Elsevier Ltd. All rights reserved.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据