相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Interrupted machining analysis for Ti6Al4V and Ti5553 titanium alloys using physical vapor deposition (PVD)-coated carbide inserts
Navneet Khanna et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2013)
Degradation modes and tool wear mechanisms in finish and rough machining of Ti17 Titanium alloy under high-pressure water jet assistance
Y. Ayed et al.
WEAR (2013)
A comparison of cryogenic and high pressure emulsion cooling technologies on tool life and chip morphology in Ti-6Al-4V cutting
M. J. Bermingham et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2012)
Cryogenic turning of the Ti-6Al-4V alloy with modified cutting tool inserts
M. Dhananchezian et al.
CRYOGENICS (2011)
An experimental study of the effect of high-pressure water jet assisted turning (HPWJAT) on the surface integrity
Malek Habak et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2011)
Effects of coolant pressure on chip formation while turning Ti6Al4V alloy
Suresh Palanisamy et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2009)
Investigation of machining performance in high-pressure jet assisted turning of Inconel 718: An experimental study
C. Courbon et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2009)
Some studies on high-pressure cooling in turning of Ti-6Al-4V
A. K. Nandy et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2009)
Characteristics of cutting forces and chip formation in machining of titanium alloys
S. Sun et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2009)
Machinability of titanium alloys (Ti6Al4V and Ti555.3)
P. -J. Arrazola et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
Influence of thermal conductivity on wear when machining titanium alloys
H. A. Abdel-Aal et al.
TRIBOLOGY INTERNATIONAL (2009)
EFFECT OF COOLANT PRESSURE, NOZZLE DIAMETER, IMPINGEMENT ANGLE AND SPOT DISTANCE IN HIGH PRESSURE COOLING WITH NEAT OIL IN TURNING Ti-6AL-4V
A. K. Nandy et al.
MACHINING SCIENCE AND TECHNOLOGY (2008)
Surface integrity of finished turned Ti-6Al-4V alloy with PCD tools using conventional and high pressure coolant supplies
Emmanuel O. Ezugwu et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2007)
Tool wear in cryogenic turning of Ti-6Al-4V alloy
K. A. Venugopal et al.
CRYOGENICS (2007)
Analysis of white layers formed in hard turning of AISI 52100 steel
A Ramesh et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
An overview of the machinability of aeroengine alloys
EO Ezugwu et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2003)
TEM study on the surface white layer in two turned hardened steels
J Barry et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2002)
Temperature reduction in the cutting zone in water-jet assisted turning
J Kaminski et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2000)
分享论文
