Starch-gelatin edible films: Water vapor permeability and mechanical properties as affected by plasticizers

Physical and mechanical properties of edible films based on blends of sago starch and fish gelatin plasticized with glycerol or sorbitol (25%, w/w) were investigated. Film forming solutions of different ratios of sago starch to fish gelatin (1:0, 2:1, 3:1, 4:1, and 5:1) were used and cast at room temperature. Amylose content of sago starch was between 32 and 34% and the protein content of the fish gelatin was found to be 81.3%. The findings of this study showed that the addition of fish gelatin in starch solutions has a significant effect (p < 0.05), resulting in films with lower tensile strength (TS) and higher water vapor permeability (WVP). On the other hand, increasing protein content (from 10.9% to 21.6%) in film samples plasticized with sorbitol showed significantly lower (p < 0.05) TS but no trend was observed in % elongation-at-break (EAB) and no differences in WVP. However, TS decreased with higher protein content in the samples when either plasticizers were used in general, but no significance differences was observed among the samples (p < 0.05) with glycerol with exception to film with high protein content (21.6%) only and no trend was observed in % EAB among samples as well. Significant difference (p < 0.05) was observed in TS and viscosity between different formulations with sorbitol. The morphology study of the sago starch/fish gelatin films showed smoother surfaces with decreasing protein in the samples with either plasticizer. DSC scans showed that plasticizers and protein content incorporated with sago starch films reduced the glass transition temperature (T-g) and melting temperature (T-m) and the melting enthalpy (Delta H-m). In this study, observation of a single T-g is an indication of the compatibility of the sago starch and fish gelatin polymers to form films at the concentration levels used. (C) 2011 Elsevier Ltd. All rights reserved.